OEM 2009 Toyota Highlander Blower Motor Resistor

2009 Toyota Highlander Parts Questions & Experts Answers

• Q: How do you remove the Blower Motor Resistor for the rear air conditioning on 2009 Toyota Highlander?

  A: The procedure to uninstall the Blower Motor Controller for rear air conditioning begins with removing the rear door scuff plate RH then continuing with the rear door opening trim Weather Strip RH. The deck board assembly needs to be removed before both No. 3 deck board and the No. 2 deck board sub-assemblies. The necessary components for removal include the tonneau cover assembly and the rear seat side cover LH together with the deck side trim box LH. First remove the rear seat side cover RH followed by jack carrier support then jack carrier cushion after which you must detach the jack assembly and jack carrier assembly. Administrator follows with deck side trim box removal from the right-hand side then removes rear flooring and deck floor board assembly. Detach the rear No. 2 seat inner belt assembly followed by disconnecting the rear seat lap type belt assemblies LH and RH. Disassemble the spot where the rear No. 2 seat meets the rear floor finish plate followed by removal of the rear seat side garnish cap alongside the deck side trim cover RH and deck side trim RH. The side trim cover RH needs to be removed if your vehicle uses manual air conditioning as well as the rear room temperature sensor from automatic air conditioning systems. Uninstall the rear combination light service cover RH along with rope hook assembly for the RH side, No. 1 luggage compartment trim hook, front deck side trim cover RH, deck trim side panel assembly RH, and roof side inner garnish assembly RH. With the disconnect completed on the connector it will be possible to remove two screws that locks in the blower motor controller.