OEM 2009 Toyota Camry Clutch Master Cylinder

2009 Toyota Camry Clutch Master Cylinder Parts Questions & Experts Answers

• Q: How to install the clutch master cylinder assembly on 2009 Toyota Camry?

  A: Installation of the clutch master cylinder assembly begins with placing a new gasket on it before tightening two nuts to 12 Nm (120 kgf-cm, 9ft-lbf). The clutch lines must be joined via Special Service Tool: 09023-00101 with special care to achieve a torque of 15 Nm (155 kgf-cm, 11ft-lbf). The clutch master cylinder receives the reservoir tube through the clip installation. Check it is not twisted and the green mark points to the correct angle before final closure. After applying MP grease to the pin and clevis bushing contact surface, install the clevis onto the clutch pedal through the new clip and pin starting from the left vehicle side. Proceed to install the brake booster assembly, combination meter assembly (for TMC and TMMK made), instrument cluster finish panel No. 1, lower instrument panel finish panels (with and without Smart Key System), No. 1 instrument panel sub-assembly, lower instrument panel finish panel LH (for TMC and TMMK made), cowl side trim sub-assembly LH, front door scuff plate LH, cowl top panel outer sub-assembly, windshield wiper link assembly, cowl top ventilator louver sub-assembly, front fender to cowl side seals (LH and RH), windshield wiper arm and blade assemblies (LH and RH), air cleaner case sub-assembly, and air cleaner cap sub-assembly. Complete the procedure by attaching the cable to the negative battery terminal then bled the clutch pipe through brake fluid addition to the reservoir before tightening to 8.3 Nm (85 kgf-cm, 74in-lbf). Check for brake fluid leakage and measure fluid levels before inspecting and adjusting the clutch pedal sub-assembly.