OEM 2008 Toyota Camry Clutch Master Cylinder

2008 Toyota Camry Clutch Master Cylinder Parts Q&A

• Q: How to remove the Clutch Master Cylinder on 2008 Toyota Camry?

  A: First connect the negative terminal cable to remove power and drain brake fluid. First remove the air cleaner cap sub-assembly and then take out the air cleaner case sub-assembly. First detach the windshield wiper assemblies from both left and right sides before you remove front fender to cowl side seals on both sides of the vehicle. Pick first the cowl top ventilator louver sub-assembly and windshield wiper link assembly before removing the cowl top panel outer sub-assembly. Following these steps you should remove both brake booster assemblies as well as front door scuff plates and cowl side trim sub-assemblies and lower instrument panel finish panels from vehicles made by TMC and TMMK. Proceed with removing the No.1 instrument panel sub-assembly together with the lower instrument panel finish panels which do or do not feature the Smart Key System and the instrument cluster finish No.1 panel and combination meter assemblies suitable for TMC and TMMK vehicles. To disconnect the clutch master cylinder push rod clevis, remove the clip along with pin until the rod disconnects. Then, disconnect the clutch reservoir tube by using pliers to slide the clip off. A container should receive any escaping fluid as you perform this step. Disconnection of the clutch line requires Special Service Tool: 09023-00101 while using a container to receive the fluid. The clutch master cylinder assembly can be taken off by removing two nuts and the assembly components and then extracting the gasket from the clutch master cylinder assembly.