OEM 2009 Scion tC Fuel Pressure Regulator

2009 Scion tC Parts Questions & Experts Answers

• Q: How to remove and replace the fuel pressure regulator on 2009 Scion tC?

  A: Start by installing the fuel suction with pump and gauge tube assembly while using a new gasket which should be placed on top of it before inserting it into the fuel tank. Proceed with the installation of the fuel pump filter and maintain the fuel sender gauge arm in a direct position. The next procedure requires the securement of 6 bolts on the fuel tank vent tube set plate to achieve 6.0 Nm (60 kgf-cm, 53 in-lbf) torque followed by the installation of the 2 bolted fuel tank protector plate with the same torque specification. The fuel tank main tube installation requires inspection of external joint conditions followed by complete insertions of the joint then proper collar clip placement and confirmation of non-removable tube position. The next step involves attaching new butyl tape to the rear floor service hole cover before connecting the wire to its connectors and then installing the cover while aligning it with the floor panel convexes without putting fasteners through those points. To complete the process connect the cable to the negative battery terminal followed by initialization of systems because some systems need a battery reconnection initialization. Check for fuel leaks before completing the installation of rear seat cushion assembly.