OEM 2008 Toyota Yaris ABS Control Module

2008 Toyota Yaris Parts Questions & Experts Answers

• Q: How to install the ABS Control Module on 2008 Toyota Yaris?

  A: The first stage of brake actuator installation starts with attaching the actuator bracket through two nuts until torque reaches 5.4 Nm (55 kgf-cm, 48 in-lbf). Before connecting the brake tube it is essential to leave the hole plug in place since new actuators arrive with pre-installed brake fluid. Begin by attaching the actuator bracket with three bolts in the sequence as numbered while tightening them to 19 Nm (194 kgf-cm, 14 ft-lbf). Attention should be paid to Special Service Tool: 09023-00100 for correct brake tube positioning on the actuator. Install using a torque wrench with 300 mm (11.81 in.) fulcrum length to reach either 14 Nm torque (143 kgf-cm, 10 ft-lbf) with the tool or 15 Nm torque (155 kgf-cm, 11 ft-lbf) without the tool. Perform the same installation and torque procedure on the remaining two brake tubes which link the actuator to the master cylinder and tube No. 1 way then the brake tube terminating at the front flexible hose. Finally connect the brake actuator connector while installing the battery carrier, battery tray and battery followed by brake fluid addition into the reservoir. Bleed the master cylinder and brake line before inspects the reservoir fluid level and searches for leakage before confirming actuator performance through Techstream.