OEM 2008 Toyota Sequoia ABS Control Module

2008 Toyota Sequoia Parts Questions & Experts Answers

• Q: How to install the ABS Control Module with the actuator bracket assembly on 2008 Toyota Sequoia?

  A: An installation of the VSC actuator begins by securely fastening the actuator with three nuts under the condition that dropping it will require a new actuator replacement. You must tighten the nuts alphabetically while maintaining an even distribution of force that reaches 22 Nm (224 kgf-cm, 16 ft-lbf). Do not damage the brake lines or wire harness during this process. Install the brake lines correctly on the brake actuator followed by putting on the clamp which should attach to the VSC actuator bracket. Use a union nut wrench to connect all 4 brake tubes applying 15 Nm torque without it or 14 Nm torque when using it while maintaining the wrench parallel to the torque wrench. The installation of brake tubes to the brake master cylinder requires a union nut wrench to tighten each tube at 20 Nm (199 kgf-cm, 14 ft-lbf) without the wrench but with 18 Nm (185 kgf-cm, 13 ft-lbf) torque when using the wrench. Ensure the wrench stays parallel to the torque wrench at all times. Into the torque wrench measure 18 Nm torque for each of the two VSC actuator connected brake tubes. Complete the connection of the VSC actuator connector then add brake fluid into the reservoir followed by purging air from the brake master cylinder, brake line and VSC actuator assembly. To complete the procedure check both the brake fluid level inside the reservoir and thoroughly investigate brake fluid leakage points.