OEM 2008 Scion xD Antenna Cable

2008 Scion xD Antenna Cable Parts Q&A

• Q: How to install the antenna cable sub-assembly and the associated components on 2008 Scion xD?

  A: The antenna cord sub-assembly assembly process involves applying tape without handling the adhesive side while using red tape to clamp antenna cord sections to the side rail spacer at each marked roof headlining point for double-tape fasteners. Continuing the procedure involves aligning the marked section with pink tape on the side rail spacer in one place before applying tape at two locations and then following the mark with tape at three locations before feeding the antenna cord through the roof headlining slit. To complete the No. 2 antenna cord sub-assembly installation you should first place five clamps while connecting the connector and torquing the bolt to 7.0 Nm (71 kgf-cm, 62 in-lbf). Proceed to install the roof headlining assembly, rear shoulder belt anchor cover, seat belt anchor cover, rear center seat outer belt assembly, upper instrument panel sub-assembly, combination meter assembly, instrument cluster finish panel sub-assembly, glove compartment door assembly, instrument cluster finish center panel sub-assembly, map light assembly, room light assembly, visor holders (RH and LH), visor assemblies (RH and LH), assist grip, front pillar garnishes (RH and LH), center pillar upper and lower garnishes (RH and LH), front seat outer belt assemblies (RH and LH), seat belt anchor cover cap, roof side inner garnish assemblies (RH and LH), deck trim side panel assemblies (RH and LH), rear seat outer belt assemblies (RH and LH), luggage hold belt striker assembly, rear deck trim cover, rear door opening trim Weather Strips (RH and LH), rear door scuff plates (RH and LH), front door opening trim Weather Strips (RH and LH), cowl side trim boards (RH and LH), No. 1 and No. 2 instrument panel under cover sub-assemblies, front door scuff plates (RH and LH), rear seat assemblies (RH and LH), No. 1 rear seat leg covers (RH and LH), No. 2 rear seat leg cover (LH), deck board assembly, and finally connect the cable to the negative battery terminal with a torque of 5.4 Nm (55 kgf-cm, 48 in-lbf) while inspecting the SRS warning light.