Toyota 86101-52620
Antenna Cable

The service procedure for antenna cables starts with disconnecting from the negative battery terminal then waiting a minimum of 90 seconds before proceeding to prevent Air Bag deployment; note that some systems could need initialization following reconnection. The service starts with deck board assembly removal before proceeding to take out the No. 1 rear seat leg cover RH, No. 1 rear seat leg cover LH, No. 2 rear seat leg cover LH, rear seat assembly RH and rear seat assembly LH. The next step includes removing the front door scuff plates which are located on RH and LH sides along with the No. 1 and No. 2 instrument panel under cover sub-assemblies and cowl side trim boards that are present on RH and LH. The next step involves taking off front door opening trim Weather Strips from both the right and left sides as well as rear door scuff plates from both sides and rear door opening trim Weather Strips from both the right and left sides. Then, remove the rear deck trim cover, luggage hold belt striker assembly, rear seat outer belt assemblies RH and LH, deck trim side panel assemblies RH and LH, roof side inner garnish assemblies RH and LH, seat belt anchor cover cap, front seat outer belt assemblies RH and LH, center pillar lower garnish RH and LH, center pillar upper garnish RH and LH, front pillar garnishes RH and LH, assist grip, visor assemblies RH and LH, visor holders RH and LH, room light assembly, and map light assembly. The next sequence requires removal of the instrument cluster finish center panel sub-assembly together with the glove compartment door assembly and instrument cluster finish panel sub-assembly followed by the combination meter assembly and upper instrument panel sub-assembly. The procedure ends with the removal of the bolt and connector along with extraction of five clamps to remove the No. 2 antenna cord sub-assembly. Next, remove the antenna cord sub-assembly by unfastening six pieces of tape and pulling out the antenna cord from the roof headlining cutout.

Take off the 6 pieces of tape and extract the antenna cord from the cutout of the roof headlining.

Align with the roof headlining marking and fasten with tape in three locations, then insert the antenna cord through the slit in the roof headlining.

First, disconnect the cable from the negative battery terminal and wait at least 90 seconds to prevent the airbag from deploying.