OEM 2008 Scion xB Parking Brake Cable

2008 Scion xB Parking Brake Cable Parts Q&A

• Q: How to install the parking brake cable on 2008 Scion xB?

  A: The first step to cable installation requires you to fasten a new parking brake cable support clamp onto the parking brake cable by using the provided 2 claws. You should put the parking brake cable into the disc brake cylinder while using clip claws to fasten it through the rear disc brake cylinder guide. The parking brake cable end needs to attach to the rear disc brake cylinder operation lever before being inserted into the body using 5 bolts at 6.0 Nm (61 kgf-cm, 53 in-lbf) torque. The cable clamp should be activated before installing the rear floor side member cover. Install the front No. 2 floor heat insulator through 3 nuts tightened to 5.5 Nm (56 kgf-cm, 49 in-lbf) and do the same for the front No. 1 floor heat insulator. Hang the center exhaust pipe assembly and secure the front floor center brace. The parking brake cable end stopper can be mounted by fastening the 2 claws onto the parking brake equalizer after which the No. 1 parking brake cable assembly requires placement of the 2 claws into the parking brake cable end stopper. Proceed with same cable installation method for both the No. 3 and No. 2 parking brake cable assemblies to the parking brake equalizer. Mount the console box by inserting 5 bolts which must be torqued to 27Nm (275kgf-cm, 20ft-lbf). Mount the console box followed by installation of console box carpet and upper console panel sub-assembly. Install the rear wheel by applying torque of 103 Nm (1050 kgf-cm, 76 ft-lbf) and perform an exhaust gas leak check.