Toyota 46420-12730
Cable

You must involve the 2 claws to attach a new parking brake cable support clamp onto the parking brake cable before starting installation of the No. 3 parking brake cable assembly. Insert the parking brake cable through the disc brake cylinder before engaging the clip claws of the parking brake cable to the rear disc brake cylinder guide. The rear disc brake cylinder operation lever should receive the cable end before the parking brake cable is installed into the body using bolts torqued to 6.0 Nm (61 kgf-cm, 53 in-lbf). Engage the cable clamp. It is essential to install the rear floor side member cover before applying 3 nuts with a torque of 5.5 Nm (56 kgf-cm, 49 in-lbf) to the front No. 2 floor heat insulator followed by installation of the front No. 1 floor heat insulator using the same nut application. Secure the installation of the center exhaust pipe assembly and the front floor center brace and parking brake cable end stopper by fitting the 2 claws onto the parking brake equalizer. Fasten the No. 1 parking brake cable assembly by having both claws attach it directly to the parking brake cable end stopper. Screw the No. 3 parking brake cable assembly to the parking brake equalizer following the same procedure for the installation of the No. 2 parking brake cable assembly. The parking brake lever sub-assemblies have to be installed after completing the parking brake lever travel adjustment and installing the console box mounting bracket with torques at 27 Nm (275 kgf-cm, 20 ft-lbf) for all 5 bolts. Put the console box assembly together with the console box carpet followed by the installation of upper console panel sub-assembly. The final step includes placing the rear wheel and torquing it to 103 Nm (1050 kgf-cm, 76 ft-lbf). An exhaust gas leak test should follow.

The first step to cable installation requires you to fasten a new parking brake cable support clamp onto the parking brake cable by using the provided 2 claws. You should put the parking brake cable into the disc brake cylinder while using clip claws to fasten it through the rear disc brake cylinder guide. The parking brake cable end needs to attach to the rear disc brake cylinder operation lever before being inserted into the body using 5 bolts at 6.0 Nm (61 kgf-cm, 53 in-lbf) torque. The cable clamp should be activated before installing the rear floor side member cover. Install the front No. 2 floor heat insulator through 3 nuts tightened to 5.5 Nm (56 kgf-cm, 49 in-lbf) and do the same for the front No. 1 floor heat insulator. Hang the center exhaust pipe assembly and secure the front floor center brace. The parking brake cable end stopper can be mounted by fastening the 2 claws onto the parking brake equalizer after which the No. 1 parking brake cable assembly requires placement of the 2 claws into the parking brake cable end stopper. Proceed with same cable installation method for both the No. 3 and No. 2 parking brake cable assemblies to the parking brake equalizer. Mount the console box by inserting 5 bolts which must be torqued to 27Nm (275kgf-cm, 20ft-lbf). Mount the console box followed by installation of console box carpet and upper console panel sub-assembly. Install the rear wheel by applying torque of 103 Nm (1050 kgf-cm, 76 ft-lbf) and perform an exhaust gas leak check.

Use pliers to pinch both ends of the claw on the cable clamp and flex the clamp to remove it.

Engage the cable clamp, then install the rear floor side member cover.

Take off the upper console panel sub-assembly.