Other Name: Belt Assembly, Front Seat; Seat Belt Lap and Shoulder Belt, Front Left; Belt & Retractor; Belt Assembly, Front Seat Outer, Driver Side
Manufacturer Note: GRAY,TRIM1#
Position: Driver Side
Part Name Code: 73220
Item Weight: 5.20 Pounds
Item Dimensions: 10.3 x 9.4 x 7.3 inches
Condition: New
Fitment Type: Direct Replacement
SKU: 73220-48040-B1
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
More Info
Fits the following 2003 Toyota Highlander Submodels:
Base, Limited | 4 Cyl 2.4 L GAS, 6 Cyl 3.0 L GAS
2003 Toyota Highlander Seat Belt
Looking for affordable OEM 2003 Toyota Highlander Seat Belt? Explore our comprehensive catalogue of genuine 2003 Toyota Highlander Seat Belt. All our parts are covered by the manufacturer's warranty. Plus, our straightforward return policy and speedy delivery service ensure an unparalleled shopping experience. We look forward to your visit!
2003 Toyota Highlander Seat Belt Parts Q&A
Q: How to replace the front seat belt on 2003 Toyota Highlander?
A: The necessary first step to replace the front seat belt involves disconnecting the negative terminal from the battery. The RH front seat inner belt assembly requires disconnecting its connector and unthreading its nut for removal. First detach the rear door scuff plate RH and the front door scuff plate RH followed by the removal of the front door opening trim Weather Strip RH and rear door opening trim Weather Strip RH as well as center pillar garnish lower RH. Start by taping the screwdriver tip before using it to eliminate the shoulder anchor cover and the floor anchor cover from the front seat outer belt assembly RH. Unplug the pretensioner connector whenever a 90-second delay has occurred since switching LOCK mode on the ignition and cutting off the battery power. Two bolts need removal from the front seat outer belt to proceed. Inspection of the tilt angle should start before locking the ELR to confirm the belt remains inside when the installation angle exceeds 45 degrees. Two bolts should attach the retractor side while the upper bolt requires a torque of 7.5 N.m (76 kgf.cm, 67 in.lbf) and the lower bolt demands 42.0 N.m (420 kgf.cm, 31 ft.lbf). Security of shoulder and floor anchors requires bolts that should reach 42.0 N.m (420 kgf.cm, 31 ft.lbf) torque. End the evaluation of the ELR lock by verifying its ability to lock when you pull the belt rapidly.