Toyota 73210-48060-B0
Lap & Shoulder Belt, Gray, Passenger Side GRAY

The process for rear seat belt replacement starts with decommissioning both RH and LH rear seat assemblies followed by removing the rear seat headrest assemblies (RH and center) and then the rear seat back board carpet (RH) before uninstalling the rear cushion (RH). Begin seat belt replacement by taking out the rear seat armrest assembly from the center and the rear seat lock control lever sub-assembly along with the rear seat shoulder belt cover and rear seatback assembly from the right-hand side. Proceed with removing the rear door scuff plate (RH), the rear door opening trim Weather Strip (RH), the tonneau cover assembly along with the deck board sub-assemblies (1, 2, and 3), the luggage compartment tray, the spare wheel cover tray and both the deck side trim boxes (RH and LH). The first step includes removal of the rear floor finish plate together with the deck trim side panel assembly from the right-hand side. The first step involves removing the rear No.1 seat belt assembly outer (RH) by uninstalling its bolt before proceeding to take out the rear seat belt assembly outer center using its nut followed by uninstalling the rear seat belt assembly inner through bolt removal. The installation of the rear seat belt assembly inner requires a bolt which needs tightening to 42.0 N.m (420 kgf.cm, 31 ft.lbf). To verify the ELR function on the outer center assembly ensure that the belt automatically locks when immediately pulled. Check the tilt angle of the ELR during installation of the rear No.1 seat belt assembly outer (RH) because the belt must stay under a 45-degree opening when locked. The floor anchor gets installed through the bolt while torque reaches 42.0 N.m (420 kgf.cm, 31 ft.lbf), and the anchor must avoid the floor panel protrusions. Next, experts must secure the bolt for the rear No.1 seat belt assembly outer at 42.0 N.m (420 kgf.cm, 31 ft.lbf).

Install the rear seat belt assembly inner with the bolt, ensuring a torque of 42.0 N.m (420 kgf.cm, 31 ft.lbf).

Install the rear No.1 seat belt assembly outer RH (733600 / 98-131), checking the tilt degree when locking the ELR to ensure the belt cannot be pulled out by over 45 degrees.