Other Name: Sensor, Speed, Front Right-Hand; ABS Wheel Speed Sensor, Front Right; Front Speed Sensor; Sensor, Speed, Front Passenger Side; ABS Wheel Speed Sensor
Position: Front Passenger Side
Replaces: 89542-35030
Part Name Code: 89542
Item Weight: 1.20 Pounds
Item Dimensions: 10.0 x 6.6 x 2.2 inches
Condition: New
Fitment Type: Direct Replacement
SKU: 89542-35100
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
More Info
Fits the following 2002 Toyota Tacoma Submodels:
Base, DLX, Limited, Pre Runner, SR5, S-Runner | 4 Cyl 2.4 L GAS, 4 Cyl 2.7 L GAS, 6 Cyl 3.4 L GAS
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
More Info
Fits the following 2002 Toyota Tacoma Submodels:
Pre Runner, S-Runner | 4 Cyl 2.7 L GAS, 6 Cyl 3.4 L GAS
2002 Toyota Tacoma Speed Sensor
Looking for affordable OEM 2002 Toyota Tacoma Speed Sensor? Explore our comprehensive catalogue of genuine 2002 Toyota Tacoma Speed Sensor. All our parts are covered by the manufacturer's warranty. Plus, our straightforward return policy and speedy delivery service ensure an unparalleled shopping experience. We look forward to your visit!
2002 Toyota Tacoma Parts Questions & Experts Answers
Q: How to service the front speed sensor on 2002 Toyota Tacoma?
A: The front speed sensor service requires disconnecting the speed sensor connector for equipment consisting of RZN191L-TRPDKAB, RZN196L-CRPDKAB, RZN196L-PRPDKAB, VZN195L-CRPDKAB and VZN195L-PRP0KAB. The sensor harness will require removal of 2 clamp bolts for 4WD and pre runner models but 4 clamp bolts for 2WD models (except pre runner) from the steering knuckle, upper arm, and side rail. Make sure to tighten the upper arm and steering knuckle bolts to 8.0 Nm (82 kgf-cm, 71 inch lbs.) and the side rail bolts to 13 Nm (130 kgf-cm, 9 ft. lbs.). The installation bolt for the speed sensor on the steering knuckle needs removal at 8.0 Nm (82 kgf-cm, 71 inch lbs.). When fitting this component check that no foreign substances exist on either the sensor or knuckle surface before installing the sensor against the knuckle and using resin clips for fresh installation. The installation process ends with a signal check of the speed sensor following the reversing of all removal procedures.