Other Name: Sensor, Speed, Front Right-Hand; ABS Wheel Speed Sensor, Front Right; Front Speed Sensor; Sensor, Speed, Front Passenger Side; ABS Wheel Speed Sensor
Position: Front Passenger Side
Replaces: 89542-35030
Part Name Code: 89542
Item Weight: 1.20 Pounds
Item Dimensions: 10.0 x 6.6 x 2.2 inches
Condition: New
Fitment Type: Direct Replacement
SKU: 89542-35100
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
More Info
Fits the following 2001 Toyota Tacoma Submodels:
Base, DLX, Limited, Pre Runner, SR5, S-Runner | 4 Cyl 2.4 L GAS, 4 Cyl 2.7 L GAS, 6 Cyl 3.4 L GAS
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
More Info
Fits the following 2001 Toyota Tacoma Submodels:
Pre Runner, S-Runner | 4 Cyl 2.7 L GAS, 6 Cyl 3.4 L GAS
2001 Toyota Tacoma Speed Sensor
Looking for affordable OEM 2001 Toyota Tacoma Speed Sensor? Explore our comprehensive catalogue of genuine 2001 Toyota Tacoma Speed Sensor. All our parts are covered by the manufacturer's warranty. Plus, our straightforward return policy and speedy delivery service ensure an unparalleled shopping experience. We look forward to your visit!
2001 Toyota Tacoma Speed Sensor Parts Q&A
Q: How to service and repair the front speed sensor on 2001 Toyota Tacoma?
A: The service and repair of the front speed sensor for RZN191L-TRPDKAB, RZN196L-CRPDKAB, RZN196L-PRPDKAB, VZN195L-CRPDKAB requires a first step which is to disconnect the speed sensor connector. The next step requires removal of the 2 clamp bolts used for 4WD and pre runner models or the 4 clamp bolts applied to 2WD models (except pre runner). When installing clamp bolts, use a torque of 8.0 Nm (82 kgf-cm, 71 inch lbs.) for upper arm and steering knuckle and 13 Nm (130 kgf-cm, 9 ft. lbs.) for side rail. The speed sensor installation bolt for the steering knuckle requires removal using the same 8.0 Nm (82 kgf-cm, 71 inch lbs.) torque specification. Installation requires a sensor surface free of foreign items while the sensor sits flat on the knuckle during installation and new resin clips must be employed. To finish the installation process use the reverse steps of removal and verify the speed sensor signal afterward.