Toyota 85212-0C012
Wiper Blade, Passenger Side

Begin the replacement of the WIPER RUBBER LH by taking off the FR wiper blade LH from the front wiper arm LH without letting the front wiper arm fold during the operation. You must first remove the FR wiper rubber LH from its position on the FR wiper blade LH before taking away its 2 wiper rubber backing plates attached to the wiper rubber LH. Two wiper rubber backing plates must be attached to the wiper rubber LH while observing the proper curvature orientation. First position the wiper rubber LH so its head section points toward the arm axle before inserting the front wiper blade into wiper rubber grooves for full connection of the components. Return to place the wiper arm on the passenger side before finishing by reattaching the wiper arm on the driver side.

The replacement process for rear wiper rubber starts with removing the rear wiper blade assembly through a series of steps that include taking off the rear wiper arm head cap and raising the rear wiper blade until it clicks with the claw while taking care to avoid breaking the claw. The wiper blade should be drawn directly from the wiper arm across the left side yet avoid bending the arm at any point during removal. Begin rubber removal by gently pulling the rubber end which extends beyond the blade stopper while avoiding brutal force to prevent either damage to the blade claw or distortion of backing plates. This procedure becomes simpler through middle blade pushing. Put the two wiper rubber backing plates onto the rear wiper rubber while ensuring proper plate alignment.

Begin replacing the WIPER RUBBER LH by removing the FR WIPER BLADE LH from the front wiper arm LH without allowing the arm to fold down. Start by removing the wiper rubber LH from the FR wiper blade LH before taking the 2 wiper rubber backing plates out from the wiper rubber LH. Installation requires orienting the 2 wiper rubber backing plates correctly before attaching them to the wiper rubber LH. The wiper rubber LH installation requires users to mount the head part first toward the arm axle. Once in position users can push the wiper blade completely over the grooves of the rubber for total adherence. Reinstall the wiper arm of the passenger side then put back the driver's side wiper arm.

First, remove the FR wiper blade LH from the front wiper arm LH, ensuring not to fold down the front wiper arm during this process.

Avoid forcefully pulling to prevent deformation of the backing plates or damage to the blade claw.

Pushing near the middle of the blade can help raise the rubber for easier removal.

Raise the rear wiper blade to the position where the meshing of the claw disengages with a click sound, being careful not to break the claw.

Installation is performed in the reverse order of removal.

Begin by removing the front wiper blade LH from the front wiper arm LH, ensuring not to fold down the front wiper arm during this process.

Reinstall the wiper arm of the passenger side before the driver's side.

First, remove the FR wiper blade LH from the front wiper arm LH, ensuring not to fold down the front wiper arm during this process.

Avoid any forceful pulling to prevent deformation of the backing plates or damage to the blade claw.

Push the front wiper blade into the grooves of the wiper rubber to ensure complete engagement.