Toyota 47730-0C022
Caliper, Passenger Side

The brake caliper service starts with front wheel removal at a torque of 110 Nm which equates to 1,150 kgf-cm or 82 ft. lbs. Special Service Tool: 09023-00100 enables the brake line disconnect while catching fluid which requires a 15 Nm (155 kgf-cm, 11 ft. lbs.) torque. The brake caliper requires removal by first removing its 2 mounting bolts at 123 Nm torque followed by the clip 2 pins and anti-rattle spring. Keep your focus on the procedure of removing the 2 pads together with their associated 4 anti-squeal shims. During installation follow the reversal of removal procedures including fluid addition into the brake reservoir before conducting brake system bleeding and leak inspection.

Start front brake caliper service by removing the front wheel while fastening the disc with hub nuts at 113 Nm (1,150 kgf-cm, 83 ft. lbs.). First disconnect the brake line by using Special Service Tool: 09023-00101, but catch all brake fluid into a container and secure it to a torque of 15 Nm (155 kgf-cm, 11 ft. lbs.). The front caliper removal starts with removing mounting bolts that require 123 Nm of torque (1,250 kgf-cm and 90 ft. lbs.). After disc clip removal and anti-rattle spring and 2 pins removal the technician should remove 2 pads while taking out 4 anti-squeal shims. The anti-rattle spring and clip retain their use in case they remain free from deformities along with cracks and indications of wear but need to be clean of rust and dirt and foreign objects. Reinstall the brake system by following the opposite order of removal steps while filling brake fluid in the reservoir and performing brake bleeding to check for any leakage.

Begin by removing the rear wheel, ensuring a torque of 110 Nm (1,150 kgf-cm, 83 ft. lbs.).

First, take out the 2 sliding pins with a torque of 88 Nm (900 kgf-cm, 65 ft. lbs.), then detach the caliper from the torque plate.

Yes, they can be reused if they are in good condition.

Prepare a wooden plate to hold the pistons, placing it between the pistons and inserting a pad on one side.

Use Special Service Tool: 09023-00100, while catching the brake fluid in a container, applying a torque of 15 Nm (155 kgf-cm, 11 ft. lbs.).