Other Name: Pad Kit, Disc Brake; Disc Brake Pad Set, Front; Brake Pad Set, Disc Brake; Disc Brake Pad Kit; Front Pads; Pad Kit, Disc Brake, Front; Disc Brake Pad Set
Position: Front
Replaces: 04465-35080, 04465-04010, 04491-35260
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
Fits the following Vehicles:
1995-1998 Toyota Tacoma | Base, DLX, Limited, Pre Runner, SR5 | 4 Cyl 2.4 L GAS, 4 Cyl 2.7 L GAS, 6 Cyl 3.4 L GAS
Other Name: Pad Kit, Disc Brake; Disc Brake Pad Set, Front; Disc Brake Pad Kit; Front Pads; Pad Kit, Disc Brake, Front; Disc Brake Pad Set
Manufacturer Note: MARK SUMITOMO PS558H
Position: Front
Replaces: 04465-04020
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
Fits the following Vehicles:
1999-2004 Toyota Tacoma | Base, Limited, Pre Runner, SR5, S-Runner | 4 Cyl 2.4 L GAS, 4 Cyl 2.7 L GAS, 6 Cyl 3.4 L GAS
Toyota Tacoma Brake Pad Set
If you're thinking about purchasing OEM parts for your Toyota Tacoma, our website is your one-stop destination. We stock an extensive selection of genuine Toyota Tacoma Brake Pad Set at pocket-friendly prices. Plus, we guarantee a swift delivery and a hassle-free return policy for your convenience.
Toyota Tacoma Brake Pad Set Parts Questions & Experts Answers
Q: How to Properly Replace a Brake Pad Set on Toyota Tacoma?
A: Begin pad replacement for the RZN191L-TRPDKAB and its similar models RZN196L-CRPDKAB RZN196L-PRPDKAB VZN195L-CRPDKAB VZN19SL-PRPDKAB by first removing the wheel for pad lining thickness examination before pad installation when the lining exceeds 1.0 mm (0.039 inch). Start by removing the clip together with two pins and an anti-rattle spring. Then remove the two pads next followed by the four anti-squeal shims. Reuse the anti-rattle spring and clip only if both components show good condition. Inspection of the disc runout and thickness should occur before new pads installation and you must use new anti-squeal shims when installing pads. Press in the brake system pistons carefully using a monkey wrench handle with tape applied around it for protection before you replace pads one by one to prevent an opposite piston from flying off. Also loosen the bleeder plug if needed to help piston retraction. Disc brake grease should be applied to both sides of inner anti-squeal shims before pad installation using proper grease placement on the new pads. Install the two pads while maintaining the rubbing face cleanse of any oil or grease presence. Fit the anti-rattle spring pieces and pins before adding the clip followed by reinstallation of the front wheel while torquing it to 103 Nm (1,050 kgf-cm, 76 ft. lbs.). To complete this process you should push down on the brake pedal several times while closely observing that the fluid sits at the maximum line.