Other Name: Absorber Set, Shock; Front Left Strut; Shock Absorber Kit; Strut Assembly; Complete Strut; Absorber Assembly, Shock, Front Driver Side
Manufacturer Note: MARK 48520-08010
Position: Front Driver Side
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
Fits the following Vehicles:
2011-2014 Toyota Sienna | Base, L, LE, Limited, XLE | 6 Cyl 3.5 L GAS
| Page 1 of 2 |Next >
1-20 of 26 Results
Toyota Sienna Shock Absorber
If you're thinking about purchasing OEM parts for your Toyota Sienna, our website is your one-stop destination. We stock an extensive selection of genuine Toyota Sienna Shock Absorber at pocket-friendly prices. Plus, we guarantee a swift delivery and a hassle-free return policy for your convenience.
Q: How to service the Shock Absorber on Toyota Sienna?
A: To service the suspension strut, remove the front wheel and detach the flexible hose bracket and ABS sensor clamps. Disconnect the stabilizer bar link and outer cowl panel. Loosen lower nuts, then remove upper nuts and lower bolts to take out the shock absorber. Check front wheel alignment post-installation.
Q: How to install the rear shock absorber assembly LH on Toyota Sienna?
A: Installation rear shock absorber assembly LH-Install rear spring bumper, rear axle beam support and shock absorber with cushion retainer and nut. Install shock absorber cap, rear wheel and tighten lock nut to 30 Nm. Lastly, screw the nut to 115 Nm and align.