During air fuel ratio sensor installation on 2ZR-FE engine control, Special Service Tool: 09224-00010 should be used with torque set at 40 Nm (408 kgf-cm, 30 ft-lbf) with the tool or 44 Nm (449 kgf-cm, 32 ft-lbf) without it. Note that the specified torque value is valid only when the tool is placed parallel to the torque wrench using a wrench with 300 mm (11.81 in.) fulcrum length and 30 mm (1.18 in.) tool length. The air fuel ratio sensor connector must get connected and then the clamp needs to be applied. First install the No. 2 cylinder head cover and then install the outer cowl top panel but only for vehicles produced by TMC and afterward for all vehicles not part of the TMC production. The windshield
Wiper Motor and link assembly must be installed following the left cowl top ventilator louver along with the center No. 1 cowl top ventilator louver and hood to cowl top seal before mounting the right front wiper arm and blade assembly and left front wiper arm and blade assembly and front wiper arm head cap. Conclusion of the exam involves checking exhaust gas leakages.