Other Name: Motor Assembly, Rear Wiper; Wiper Motor; Motor
Position: Rear
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
Fits the following Vehicles:
1993-1996 Toyota Corolla | Base, DX, LE | 4 Cyl 1.6 L GAS, 4 Cyl 1.8 L GAS
| Page 1 of 2 |Next >
1-20 of 29 Results
Toyota Corolla Wiper Motor
Choose genuine Wiper Motor that pass strict quality control tests. You can trust the top quality and lasting durability. Shopping for OEM Wiper Motor for your Toyota Corolla? Our website is your one-stop destination. We stock an extensive selection of genuine Toyota Corolla parts. The price is affordable so you can save more. It only takes minutes to browse and find the exact fit. Easily add to cart and check out fast. Our hassle-free return policy will keep you stress-free. We process orders quickly for swift delivery. Your parts will arrive faster, so you can get back on the road sooner.
Q: How to remove the front wiper motor on Toyota Corolla?
A:
The first step to access the front wiper motor requires removing both windshield wiper arm covers before stripping the front wiper arm head cap. Detach the front wiper arm with its blade assembly on the left-hand side by removing the nut and repeat the same step on the right-hand side. Use a screwdriver to unfasten the seven clips which enables you to take off the hood to cowl top seal. Disengage the clip and 14 claws respectively to extract the center No. 1 cowl top ventilator louver while using the same procedure to separate the left-hand cowl top ventilator louver by removing its clip and 8 claws. The procedure starts by disconnecting the connector followed by unbolted removal of two bolts that permits taking out of the windshield wiper motor and link assembly. A taped screwdriver tip should be used to disconnect the rod that extends from the crank arm pivot of the windshield wiper motor assembly. After disconnecting the connector by removing electrical tape from the wire harness proceed to take out the 3 bolts securing the windshield wiper motor assembly. The windshield wiper link assembly becomes easier to detach from the assembly with crank arm rotating.
Q: How to install the windshield wiper motor assembly and related components on Toyota Corolla?
A:
The windshield wiper motor assembly installation requires bolt attachment with 5.4 Nm torque (55 kgf-cm, 48 in-lbf) and connector connection with new electrical tape applied to the wire harness where it was detached to provide secure board attachment. Use MP grease for applying to the crank arm pivot of the windshield wiper motor assembly then link the rod of the windshield wiper link assembly to this pivot point. Fasten the windshield wiper motor and link assembly using two bolts that should be torqued to 5.5 Nm (56 kgf-cm, 49 in-lbf) while connecting the connector. Personnel should engage the clip with eight claws for installing the cowl top ventilator louver LH and the clip with fourteen claws for the center No. 1 cowl top ventilator louver. Begin the installation of cowl top seal by attaching its seven clips. The installation of the front wiper arm and blade assembly RH requires operation of the wiper control to bring the windshield wiper motor to stop at the automatic position when the vehicle will be cleaned with a wire brush then the assembly will be installed with the nut torqued to 26 Nm (265 kgf-cm, 19 ft-lbf) while the installer holds the arm hinge to fasten the nut. Spray washer fluid on the windshield to validate the front wipers do not touch any vehicle body while testing the LH front arm and blade assembly through the same installation process. Process by installing the 2 front wiper arm head caps as the last step.