OEM 2010 Scion xD Wiper Motor

2010 Scion xD Wiper Motor Parts Q&A

• Q: How to install the front wiper motor and related components on 2010 Scion xD?

  A: Start front wiper motor installation by mounting the 3 retaining bolts with a torque level of 5.5 Nm (56 kgf-cm, 49 in-lbf). The installation requires attaching the crank arm to the front wiper motor by aligning their matchmarks then tightening the nut to 5.5 Nm (56 kgf-cm, 49 in-lbf). Before attaching the wiper motor rod apply MP grease to its sliding components along with those of the wiper motor. After connector installation the front wiper motor and link engagement enables the rubber pin to connect with the body through 2 bolts tightened to 5.5 Nm (56 kgf-cm, 49 in-lbf) and with the clamp engaged position. Attach cowl top ventilator louver LH by using five claws and five guides which must be followed by attaching the clip. Before attaching the clip for the cowl top ventilator louver RH, it is necessary to apply the 4 claws and 4 guides first. The installation of the hood to cowl top seal requires you to fasten the 7 clips in place. The front wiper arm and blade assembly needs to be cleaned of any metal powder from its wiper arm serrated portion along with wiper pivot serrations before operating the wiper until automatic stop position. Insert the blade tip to the glass mark then secure the front wiper arm nut to 26 Nm (265 kgf-cm, 19 ft-lbf). Apply the same set of instructions for installing the front wiper assembly RH. The installation of 2 front wiper arm head caps requires usage of the 2 claws until they are properly attached.