OEM 2009 Toyota Camry Cabin Air Filter

2009 Toyota Camry Cabin Air Filter Parts Q&A

• Q: How to replace the Cabin Air Filter and its components on 2009 Toyota Camry?

  A: The Plasmacluster needs two screws that require a torque of 5.4 Nm (55 kgf-cm, 48 in-lbf) for security installation. The first step is to install the No. 1 heater to register duct then the side No. 1 defroster nozzle duct follows. Install instrument panel stay No. 3 before placing the instrument panel safety pad assembly which suits both TMC and TMMK production vehicles. After that, install the No. 1 heater to register duct as well as the side No. 1 defroster nozzle duct. Finally install the instrument panel No. 1 speaker panel sub-assembly and front No. 2 speaker assembly for the LH side and No. 1 defroster nozzle garnish. Install the instrument panel No. 1 register assembly while also adding the front pillar garnish LH followed by the front No. 2 speaker assembly for the RH side and the instrument panel No. 2 speaker panel sub-assembly along with the instrument panel No. 3 register assembly. Add the front pillar garnish RH along with the No. 1 console box insert front for vehicles produced by TMC and TMMK and the No. 2 console box insert front which serves all TMC and TMMK models. Install the console box assembly that serves TMC and TMMK made vehicles and place both console box carpet and the console box pocket. All installation of radio receiver and heater control panel follows the receiver type. Install the radio receiver with heater control panel assembly without Navigation System or the navigation receiver with heater control panel assembly with Navigation System. Install the instrument panel No. 2 register assembly as well as the upper console panel sub-assembly for both TMC and TMMK made vehicles together with the upper console rear panel sub-assembly for Automatic and Manual Transaxle. Install the Automatic Transaxle floor shift position indicator housing sub-assembly with the Manual Transaxle upper console panel as well as both No. 2 instrument cluster finish panel garnish and No. 1 instrument cluster finish panel garnish. The workforce should install the shift lever knob sub-assembly that serves Automatic and Manual Transaxle vehicles as well as the lower instrument panel for both TMC and TMMK made vehicles and the instrument panel No. 2 under cover sub-assembly. The workforce must place the cowl side trim sub-assembly RH as well as front door scuff plate RH and combination meter assembly for both TMC and TMMK made vehicles and instrument cluster finish panel No. 1 along with lower instrument panel finish panel (with or without Smart Key System). The installation includes placing the No. 1 instrument panel assembly and turn signal switch assembly with spiral cable sub-assembly and performing spiral cable sub-assembly adjustment procedures. The workforce should install both steering column covers and lower instrument panel finish panels (LH) for TMC and TMMK vehicles together with cowl side trim sub-assembly LH and front door scuff plate LH. Complete the installation of the steering wheel assembly and steering pad while installing lower No. 3 and No. 2 steering wheel covers then reconnect the negative battery terminal before beginning inspection of the steering pad and checking the SRS warning light.