Toyota 87139-07010
Element

The air conditioning will perform at peak efficiency when air conditioning filters receive standard replacement or cleaning service. Turning the "ENGINE START STOP" switch OFF is the first step to perform when dealing with vehicles that use smart key technology. Push the glove box until its claws release from the hooks and then pull out the damper piece. Remove the filter cover. Holding the air gun at 72 psi during a 2-minute compressed air blow cleaning process from the filter's downward direction will suffice for dirty filter clearance. However, professional Toyota dealer service is needed if compressed air is unavailable. To replace the air conditioning filter remove it from its position and put on a new clean filter lining up the "UP" marks properly. The maintenance schedule determines when to inspect and clean or replace the air conditioning filter; homes and busy traffic areas prompt extra cleaning together with early replacement. Check the filter whenever the ventilated airflow decreases strongly because it might need replacement.

The servicing process for the cabin air filter should concentrate on examination and maintenance of parts used for air conditioning system operations and Plasmacluster technology functionality. All necessary parts need thorough inspection followed by maintenance to guarantee peak system performance.

The service of the cabin air filter begins by removing the glove compartment door subassembly before taking off the No. 2 finish panel lower. First step to remove the filter cover requires releasing the 2 claws then pulling out the air refiner filter from its upper position before detaching it from the lower side. Users must follow an opposite progression when performing filter installation compared to the removal steps.

Remove the front pillar garnish LH, instrument panel No. 1 register assembly, instrument panel No. 1 speaker panel sub-assembly, front No. 2 speaker assembly (for LH Side), front pillar garnish RH, instrument panel No. 3 register assembly, instrument panel No. 2 speaker panel sub-assembly, and front No. 2 speaker assembly (for RH Side).

To check and replace the filter, open the glove box, slide off the damper, push each side of the glove box to disconnect the claws, remove the filter cover by pushing in both ends, pull the filter out, and inspect its surface.

To maintain optimal air quality within the vehicle.

Remove the No. 2 and No. 1 console box insert fronts, front pillar garnish LH, instrument panel No. 1 register assembly, instrument panel No. 1 speaker panel sub-assembly, front No. 2 speaker assembly for LH side, front pillar garnish RH, instrument panel No. 3 register assembly, instrument panel No. 2 speaker panel sub-assembly, and front No. 2 speaker assembly for RH side.