How to install the Starter Motor on 2009 Toyota 4Runner?

Question

Accepted Answer

The 2WD starter assembly installation requires attaching 2 bolts with torque set to 37 Nm (377 kgf-cm, 27 ft-lbf) and linking the wire harness to terminal 30 and securing the nut with a torque of 9.8 Nm (100 kgf-cm, 7 ft-lbf). Terminal 50 also needs connection to the starter assembly. After connector attachment to the cylinder block you should install the bolt with a torque value of 13 Nm (133 kgf-cm, 10 ft-lbf). Before installing the engine rear under cover assembly with four bolts at a torque setting of 29 Nm (296 kgf-cm, 21 ft-lbf), use three bolts to fasten the No. 2 manifold stay with a torque of 40 Nm (408 kgf-cm, 30 ft-lbf). Pop on the negative battery terminal for the completion of the process. To install the starter assembly for 4WD vehicles use 2 bolts torqued at 37 Nm (377 kgf-cm, 27 ft-lbf) while connecting the wire harness to terminal 30 then securing it with a nut torqued to 9.8 Nm (100 kgf-cm, 7 ft-lbf) and termial 50 attached to the starter assembly. After fitting the steering sliding yoke to the No. 2 steering intermediate shaft bolt A and B must be tightened to 36 Nm (370 kgf-cm, 27 ft-lbf). Secure the front fender rear splash shield on the left side with 5 clips and add 2 new gaskets and install the No. 2 exhaust manifold with 2 bolts and 2 nuts which require torquing to 48 Nm (490 kgf-cm, 35 ft-lbf) and 62 Nm (630 kgf-cm, 46 ft-lbf). Then install the heated oxygen sensor (bank 2) connector. The end of the installation process includes engine rear under cover assembly bolt installation using 4 bolts at 29 Nm (296 kgf-cm, 21 ft-lbf) torque while connecting the battery negative terminal.

OEM 2009 Toyota 4Runner Starter Motor

4 Starter motors found

2009 Toyota 4Runner Starter

2009 Toyota 4Runner Starter

2009 Toyota 4Runner Starter

2009 Toyota 4Runner Starter

2009 Toyota 4Runner Starter Motor

2009 Toyota 4Runner Starter Motor Parts Q&A

Related 2009 Toyota 4Runner Parts

Alternate Year Models