Other Name: Sensor, Seat Position; Seat Track Position Sensor, Left; Air Bag Sensor; Seat; Sensor, Seat Position Air Bag
Position: Driver Side
Part Name Code: 89178A
Item Weight: 0.50 Pounds
Item Dimensions: 2.1 x 1.6 x 1.4 inches
Condition: New
Fitment Type: Direct Replacement
SKU: 89178-0W010
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
More Info
Fits the following 2009 Toyota 4Runner Submodels:
Limited, Sport, SR5 | 6 Cyl 4.0 L GAS, 8 Cyl 4.7 L GAS
2009 Toyota 4Runner Air Bag Sensor
Looking for affordable OEM 2009 Toyota 4Runner Air Bag Sensor? Explore our comprehensive catalogue of genuine 2009 Toyota 4Runner Air Bag Sensor. All our parts are covered by the manufacturer's warranty. Plus, our straightforward return policy and speedy delivery service ensure an unparalleled shopping experience. We look forward to your visit!
2009 Toyota 4Runner Parts Questions & Experts Answers
Q: How to install the rear Air Bag sensor LH on 2009 Toyota 4Runner?
A: Perform the rear Air Bag sensor LH installation while the ignition switch remains off and disconnect the battery negative terminal for at least 90 seconds before starting work. Use 2 bolts to fasten the rear Air Bag sensor LH where tightening the fasteners reaches 17.5 Nm (179 kgf-cm, 13 ft-lbf). The rear Air Bag sensor LH requires replacement with a new one when it has suffered a drop impact or presents any case or bracket or connector defects including cracks or dents. Wiring connecting to SRS must avoid contact with or trapping by other parts during the installation process while thoroughly checking for loose parts. The installation follows an order starting with connecting the connector to the rear Air Bag sensor LH then proceeding through deck side trim cover LH, deck trim side board UPR LH, lap belt outer anchor cover rear No. 1 seat, rear door opening trim Weather Strip LH, rear door scuff plate LH, deck floor box LH, rear floor mat support plate rear, deck board assembly, and tonneau cover retractor sub-assembly. The last step involves checking the SRS warning light before placing the cable back on the negative terminal.