OEM 2009 Scion tC ABS Control Module

2009 Scion tC ABS Control Module Parts Q&A

• Q: How to install the ABS Control Module on 2009 Scion tC?

  A: The procedures for installing the brake actuator assembly demand that you join it to the bracket by tightening 2 nuts while reaching an torque of 5.4 Nm (55 kgf-cm, 48 in-lbf). The brake actuator assembly requires two bolts and one nut for installation onto the bracket. When tightening the bolts to 19 Nm (194 kgf-cm, 14 ft-lbf) use caution to avoid brake tube and wire harness damage and follow installation ordering illustrated on the drawing. Connect the brake actuator connector while securely locking the lever before installing 6 brake tubes onto the actuator using Special Service Tool: 09023-00101 at the proper locations by applying torque up to 14 Nm (145 kgf-cm, 10 ft-lbf) followed by 15 Nm (155 kgf-cm, 11 ft-lbf) using a torque wrench with a 30 cm (11.81 in.) fulcrum length. Install the right headlight unit after placing the front bumper cover and the front fender liner onto both sides as well as installing the hood to front end panel seal. The right front wheel must receive a torque of 103 Nm (1,050 kgf-cm, 76 ft-lbf). Next, attach the cable to the negative battery terminal before possible system initialization steps occur after battery reconnection. The process includes adding brake fluid to the reservoir followed by bleeding air from both the brake master cylinder and brake line. Additionally check the brake fluid level before inspecting for fluid leaks. Use Techstream to inspect the brake actuator before beginning headlight aiming procedures and headlight aiming assessment for required inspections.