OEM 2008 Toyota Sequoia Wiper Motor

2008 Toyota Sequoia Wiper Motor Parts Q&A

• Q: How to install the windshield wiper motor assembly on 2008 Toyota Sequoia?

  A: Fasten the 3 bolts onto the windshield wiper motor assembly with 7.0 Nm torque (71 kgf-cm, 62 in-lbf) before aligning and connecting the crank arm to the front wiper motor. Torque the nut mounting the crank arm to 7.0 Nm (71 kgf-cm, 62 in-lbf). Put MP grease on the crank arm pivot and link the wiper rod to the arm. Insert the wiper motor and link setup on 4 mounting bolts and a nut with 7.0 Nm torsion (71 kgf-cm, 62 in-lbf). Then link the electrical connector. Fasten the 6 claw hooks and 8 routing guides onto the cowl top ventilator louver part before attaching 2 clips in place. To install the front fender to cowl side seal RH, push the claw into position and duplicate the same steps on the LH side. Before installing the wiper blade on the wiper arm you need to remove metal powder by brushing the serrations on both the arm and wiper pivot station. Fully engage and automatically stop the wiper system, line up the blade tip to the glass mark, apply force to the wiper arm hinge, then secure the nut to 20 Nm of torque (204 kgf-cm, or 15ft-lbf). Use the washer fluid on the windshield to check if the front wipers work correctly without any blockages. Perform identical operations for cleaning, aligning, tighting and testing the left-hand front wiper arm and blade assembly.