Other Name: Emblem, Back Door; Hatch Emblem, Rear; Door Emblem, Rear; Nameplate
Manufacturer Note: RAV4
Position: Rear
Replaces: 75431-42020, 75431-42150, 75431-42030
Part Name Code: 75431A
Item Weight: 0.80 Pounds
Condition: New
Fitment Type: Direct Replacement
SKU: 75431-0R060
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
More Info
Fits the following 2008 Toyota RAV4 Submodels:
Adventure, Base, Hybrid Limited, Hybrid SE, Hybrid XLE, L, LE, Limited, Platinum, SE, Sport, XLE | 4 Cyl 2.4 L GAS, 4 Cyl 2.5 L FULL HYBRID EV-GAS (FHEV), 4 Cyl 2.5 L GAS, 6 Cyl 3.5 L GAS
Other Name: Plate, Back Door Name; Door Emblem, Rear
Position: Rear
Part Name Code: 75441C
Item Weight: 0.50 Pounds
Condition: New
Fitment Type: Direct Replacement
SKU: 75441-42050
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
More Info
Fits the following 2008 Toyota RAV4 Submodels:
Base, Limited, Sport | 4 Cyl 2.4 L GAS, 4 Cyl 2.5 L GAS, 6 Cyl 3.5 L GAS
2008 Toyota RAV4 Emblem
Looking for affordable OEM 2008 Toyota RAV4 Emblem? Explore our comprehensive catalogue of genuine 2008 Toyota RAV4 Emblem. All our parts are covered by the manufacturer's warranty. Plus, our straightforward return policy and speedy delivery service ensure an unparalleled shopping experience. We look forward to your visit!
2008 Toyota RAV4 Emblem Parts Q&A
Q: How to remove the body emblem and name plate without damaging them or the body on 2008 Toyota RAV4?
A: A heat light should replace excessive heat when removing vehicle emblems and name plates from the body because it achieves standard heating levels. The first step includes removing the No. 1 back door emblem assembly by applying protective tape around both sides and using piano wire between body and emblem to secure wooden handles on either end to pull off adhesive securing the emblem. Use extreme caution when you remove both the emblem and its mounting points because you plan to reuse them. The next step requires using protective tape to wrap the back door name plate before running a piano wire between the vehicle body and plate while tying handles to the wire ends to scrape off the double-sided tape. Apply the same caution while removing the double-sided tape because it could hurt both the name plate and the vehicle body. The process to handle the No. 1 back door emblem matches the steps used earlier in this procedure. For the removal of the No. 4 back door name plate (for 4WD) complete the procedure by applying protective tape then inserting a piano wire, tying handles to the ends and pulling wire to detach the name plate with the understanding that it may stay on for reinstallation.