Other Name: Plate, Front Fender Name; Fender Emblem, Front Left
Manufacturer Note: HYBRID
Position: Front Driver Side
Replaces: 75362-42030
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
Fits the following Vehicles:
2016-2018 Toyota RAV4 | Adventure, Hybrid Limited, Hybrid SE, Hybrid XLE, LE, Limited, Platinum, SE, XLE | 4 Cyl 2.5 L FULL HYBRID EV-GAS (FHEV), 4 Cyl 2.5 L GAS
Other Name: Garnish, Radiator Grille; Grille Emblem, Front
Position: Front
Replaces: 53141-42020
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
Fits the following Vehicles:
2016-2018 Toyota RAV4 | Adventure, Hybrid Limited, Hybrid SE, Hybrid XLE, LE, Limited, Platinum, SE, XLE | 4 Cyl 2.5 L FULL HYBRID EV-GAS (FHEV), 4 Cyl 2.5 L GAS
Other Name: Plate, Rear Name; Door Emblem, Rear; Plate, Rear Body Name
Position: Rear
Replaces: 75471-13040
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
Fits the following Vehicles:
1996-2000 Toyota RAV4 | Base | 4 Cyl 2.0 L GAS
| Page 1 of 4 |Next >
1-20 of 76 Results
Toyota RAV4 Emblem
If you're thinking about purchasing OEM parts for your Toyota RAV4, our website is your one-stop destination. We stock an extensive selection of genuine Toyota RAV4 Emblem at pocket-friendly prices. Plus, we guarantee a swift delivery and a hassle-free return policy for your convenience.
Toyota RAV4 Emblem Parts Questions & Experts Answers
Q: How to remove the body emblem and name plate without damaging them or the body on Toyota RAV4?
A: A heat light should replace excessive heat when removing vehicle emblems and name plates from the body because it achieves standard heating levels. The first step includes removing the No. 1 back door emblem assembly by applying protective tape around both sides and using piano wire between body and emblem to secure wooden handles on either end to pull off adhesive securing the emblem. Use extreme caution when you remove both the emblem and its mounting points because you plan to reuse them. The next step requires using protective tape to wrap the back door name plate before running a piano wire between the vehicle body and plate while tying handles to the wire ends to scrape off the double-sided tape. Apply the same caution while removing the double-sided tape because it could hurt both the name plate and the vehicle body. The process to handle the No. 1 back door emblem matches the steps used earlier in this procedure. For the removal of the No. 4 back door name plate (for 4WD) complete the procedure by applying protective tape then inserting a piano wire, tying handles to the ends and pulling wire to detach the name plate with the understanding that it may stay on for reinstallation.