OEM 2008 Toyota Camry Antenna

2008 Toyota Camry Antenna Parts Q&A

• Q: How to install the navigation antenna assembly and related components on 2008 Toyota Camry?

  A: You must fasten the navigation antenna assembly by means of two screws that also need to connect with three clamps. The installation of TMC Made vehicles requires starting with No. 2 heater to register duct, then following with No. 3 heater to register duct and finally No. 1 heater to register duct before continuing with defroster nozzle assembly and the side No. 2 and No. 1 defroster nozzle ducts. You should follow the identical component installation process for TMMK Made vehicles as described for the specific components. After the No. 3 instrument panel stay, workers must add the instrument panel safety pad assembly and No. 1 defroster nozzle garnish along with front No. 2 speaker assembly (LH side), instrument panel No. 1 speaker panel sub-assembly and instrument panel No. 1 register assembly and front pillar garnish LH followed by front No. 2 speaker assembly (RH side). Implement the same installation steps on the Right Hand (RH) side which were applied to the Left Hand (LH) side. Continue with the installation of the instrument panel No. 2 speaker panel sub-assembly, instrument panel No. 3 register assembly, front pillar garnish RH, No. 1 console box insert front (for both TMC and TMMK Made), No. 2 console box insert front (for both TMC and TMMK Made), console box assembly (for both TMC and TMMK Made), console box carpet, console box pocket, navigation receiver with heater control panel assembly, instrument panel No. 2 register assembly, upper console panel sub-assembly (for both TMC and TMMK Made), upper console rear panel sub-assembly (for both Automatic and Manual Transaxle), floor shift position indicator housing sub-assembly (for Automatic Transaxle), upper console panel (for Manual Transaxle), No. 2 instrument cluster finish panel garnish, No. 1 instrument cluster finish panel garnish, shift lever knob sub-assembly (for both Automatic and Manual Transaxle), lower instrument panel sub-assembly (for both TMC and TMMK Made), instrument panel No. 2 under cover sub-assembly, cowl side trim sub-assembly RH, front door scuff plate RH, combination meter assembly (for both TMC and TMMK Made), instrument cluster finish No. 1 panel, lower instrument panel finish panel (with and without Smart Key System), and No. 1 instrument panel sub-assembly. Then install the turn signal switch assembly with spiral cable sub-assembly while performing spiral cable sub-assembly adjustment and place the steering column cover (for both TMC and TMMK Made). Continue with the lowest instrument panel trim panel installation for both TMC and TMMK Made vehicles followed by cowl side trim addition LH, front door scuff plate LH, steering wheel assembly, steering pad, lower No. 3 steering wheel cover, and lower No. 2 steering wheel cover. Check the SRS warning light while connecting the cable to the negative battery terminal then inspect both the steering pad.