Toyota 86300-06071
Antenna

After hooking the antenna assembly with two claws, guide the antenna cord through its cutout on the antenna nut until tightening both with a 4.5 Nm (45 kgf-cm, 40 in-lbf) torque rating and connecting the connector. Users must inspect existing double-sided tape on the antenna cord sub-assembly with satellite radio. If tape remains adhesive, they can reuse it but must apply new tape by removing outdated tape then peeling fresh tape before precise placement on the roof headlining assembly which must match the given markings. Fasten the antenna cord to the vehicle's front side while keeping the taped section positioned adjacent to the roof headlining bump and secure it through tape usage. When double-sided tape loses its stickiness, packing tape will ensure proper adhesion. The marking tape for right front corner installation must match the protrusion on roof headlining before applying tape to secure the antenna cord and headlining assembly while the marking tape for rear corner should match the headlining edge. The installation of the antenna cord sub-assembly without satellite radio requires the same steps. The installation of the No. 2 antenna cord sub-assembly begins by using the six clamps and clip. To register ducts for TMC Made and TMMK Made begin with the No. 2 heater installation before moving to the No. 3 heater and finishing with installation of the No. 1 heater. Finish the installation phase by putting together the defroster nozzle assembly along with the side defroster nozzle duct for both TMC Made and TMMK Made and proceeding to mount the instrument panel safety pad assembly for both TMC Made and TMMK Made.

Install the upper console rear panel sub-assembly for both automatic and manual transaxles, the floor shift position indicator housing sub-assembly for automatic transaxles, and the upper console panel for manual transaxles.

Ensure the front wheels are aligned straight ahead and disconnect the cable from the negative battery terminal, waiting 90 seconds to prevent airbag deployment.

Remove the lower No. 3 steering wheel cover, lower No. 2 steering wheel cover, steering pad, and steering wheel assembly.

Remove the instrument panel No. 2 register assembly, the navigation receiver with heater control panel assembly, the console box pocket, the console box carpet, and the console box assembly.