How to install the exhaust pipe on 2008 Toyota Avalon?

Question

Accepted Answer

Start the 2GR-FE engine exhaust pipe installation by putting the exhaust tail pipe baffle groove where it matches the exhaust pipe tail projection after you connect the 5 exhaust pipe supports and attach the 2 exhaust pipe tails. First install two bolting points of 19 Nm (194 kgf-cm, 14 ft-lbf) torque between the exhaust pipe center and the exhaust pipe damper. This process must be followed by applying new gaskets and connecting 2 exhaust pipe supports between them before securing the exhaust pipe center to the 2 exhaust pipe tails. Then tighten the 4 nuts with 43 Nm (438 kgf-cm, 32 ft-lbf) torque. Begin by installing 3 new gaskets to exhaust pipe fronts then use 2 nuts and 2 bolts to fasten the exhaust manifolds and pipe fronts at 62 Nm (632 kgf-cm, 46 ft-lbf) torque. After that, join the exhaust pipe front to center utilising 2 nuts and 2 bolts at 56 Nm (571 kgf-cm, 41 ft-lbf) torque. The rear exhaust pipe No. 1 support bracket can be installed using 2 bolts at 33 Nm (337 kgf-cm, 24 ft-lbf) torque while maintaining proper bracket orientation before adding front exhaust pipe No. 1 support bracket with matching 2 nuts at this torque value. Place and tighten the 2 heated oxygen sensors (bank 1, 2 sensor 2) to 44 Nm (449 kgf-cm, 32 ft-lbf) using a torque converter while attaching their corresponding connectors. Exhaust gas leaks should be checked following installation while necessary areas need tightening until leaks stop and damaged parts require replacement.

OEM 2008 Toyota Avalon Exhaust Pipe

4 Exhaust Pipes found

2008 Toyota Avalon Center Pipe

2008 Toyota Avalon Muffler W/Tpipe, Driver Side

2008 Toyota Avalon Muffler W/Tpipe, Passenger Side

2008 Toyota Avalon Front Pipe

2008 Toyota Avalon Exhaust Pipe

2008 Toyota Avalon Exhaust Pipe Parts Q&A

Related 2008 Toyota Avalon Parts

Alternate Year Models