Other Name: Switch Assembly, Neutral; Switch Assembly, Neutral Start
Part Name Code: 84540
Item Weight: 0.70 Pounds
Item Dimensions: 7.6 x 3.6 x 1.6 inches
Condition: New
Fitment Type: Direct Replacement
SKU: 84540-52080
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
More Info
Fits the following 2008 Scion xD Submodels:
Base | 4 Cyl 1.8 L GAS
2008 Scion xD Neutral Safety Switch
Looking for affordable OEM 2008 Scion xD Neutral Safety Switch? Explore our comprehensive catalogue of genuine 2008 Scion xD Neutral Safety Switch. All our parts are covered by the manufacturer's warranty. Plus, our straightforward return policy and speedy delivery service ensure an unparalleled shopping experience. We look forward to your visit!
2008 Scion xD Parts Questions & Experts Answers
Q: How to install the park/neutral safety switch assembly onto the manual valve lever shaft on 2008 Scion xD?
A: The manual valve lever shaft installation requires an initial provision of the 2 bolts along with a fresh lock plate which should be firmly tightened to 6.9 Nm (70 kgf-cm, 61 in-lbf). The control shaft lever gets provisionally installed before rotating it counterclockwise to its stopping point then clockwise through 2 notches before removal. Fasten the park/neutral position switch assembly at the neutral basic line by tightening its two bolts to 5.4 Nm (55 kgf-cm, 48 in-lbf). Fitting the nut inside the lock plate requires manual screwdriver insertion before adding the control shaft lever with washer and concluding with a torque specification of 13 Nm (129 kgf-cm, 9 ft-lbf). Install the connector which will function as the park/neutral position switch assembly. The transmission control cable assembly requires installation onto the control shaft lever with the nut before tightening to 12 Nm (122 kgf-cm, 9 ft-lbf) torque and fastening to the control cable bracket with a new clip which needs proper alignment of the cable mark with the slit on the transmission control cable bracket. Examine the position of the shift lever together with the assembly of the park/neutral position switch. Screw in the engine under cover LH while tightening it to 5.0 Nm (51 kgf-cm, 44 in-lbf).