Other Name: Pipe Assembly, Exhaust; Exhaust Muffler; Direct-Fit Exhaust; Exhaust System Kit; Exhaust Pipe; Tail Pipe; Muffler
Replaces: 17420-28711, 17420-28620, 17420-28710
Item Weight: 16.80 Pounds
Item Dimensions: 50.9 x 20.2 x 9.3 inches
Condition: New
SKU: 17420-28712
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
More Info
Fits the following 2007 Toyota RAV4 Submodels:
Base, Limited, Sport | 4 Cyl 2.4 L GAS
2007 Toyota RAV4 Exhaust Pipe
Looking for affordable OEM 2007 Toyota RAV4 Exhaust Pipe? Explore our comprehensive catalogue of genuine 2007 Toyota RAV4 Exhaust Pipe. All our parts are covered by the manufacturer's warranty. Plus, our straightforward return policy and speedy delivery service ensure an unparalleled shopping experience. We look forward to your visit!
2007 Toyota RAV4 Parts Questions & Experts Answers
Q: How to service and repair the exhaust pipe on 2007 Toyota RAV4?
A: The repair process for the exhaust pipe begins with disconnecting the negative battery cable before allowing at least 90 seconds of waiting time to disable Air Bag and seat belt pretensioners. You need to remove the heated oxygen sensor from Bank 1 Sensor 2 before removing the tailpipe assembly through dismantling its two bolts and two compression springs and disconnecting its two exhaust pipe supports and then taking off the central exhaust pipe gasket. To remove the center exhaust pipe assembly operate by detaching the two bolts and disconnecting the supports for all three exhaust pipe supports before you take off the gasket from the front exhaust pipe. You should disconnect the front exhaust pipe by removing its 2 bolts and 2 compression springs and front exhaust pipe and then take off the exhaust manifold gasket. The installation of the front exhaust pipe assembly requires measuring the compression spring free length with a vernier caliper; replace the spring if its length is less than 41.5 mm (1.634 inch). Use a new gasket which must be fully flat against the exhaust manifold and oriented properly while avoiding reinstallation of the discarded gasket or shoving it inside during the assembly process. Fasten the front exhaust pipe using 2 compression springs and 2 bolts that require a torque of 43 Nm (438 kgf-cm, 32 ft. lbs.). The center exhaust pipe installation requires new gasket placement on the front exhaust pipe before adding 2 bolts that should be torqued to 43 Nm (438 kgf-cm, 32 ft. lbs.). Free length measurement of the compression spring should be assessed before tailpipe assembly installation because replacement is needed when the length is less than 38.5 mm (1.516 inch). A new gasket must be installed by hand with its surface facing the correct direction and the center exhaust pipe while keeping it free of the removed gasket and avoiding pushing it into position during assembly. Connect the exhaust pipe supports before proceeding to install the tailpipe while tightening its 2 compression springs and 2 bolts to 43 Nm (438 kgf-cm, 32 ft. lbs.). After installing the heated oxygen sensor (for Bank 1 Sensor 2) reconnect the cable to the negative terminal of the battery and inspect exhaust gas leakage before tightening affected areas to stop all leaks while replacing any broken components.