OEM 2007 Toyota Camry Wiper Motor

2007 Toyota Camry Wiper Motor Parts Questions & Experts Answers

• Q: How to service the front wiper motor on 2007 Toyota Camry?

  A: You should start front wiper motor servicing by detaching the front wiper arm with its blade assembly LH by uninstalling the nut then repeating the same steps for the front wiper arm and blade assembly RH. Move on to disengage the claw and then extract both front fender to cowl side seals starting with the LH before moving to the RH side seal. You must disconnect the cowl top ventilator louver sub-assembly through the process of removing its 2 clips while disengaging the 4 claws. Disconnect the wiring connector before unsticking the 4 fasteners which allows you to pull out the windshield wiper motor assembly with its link system. Apply the screwdriver to detach the No. 2 windshield wiper link rod from the crank arm pivot of the front wiper motor assembly before moving the crank arm as indicated to remove 3 bolts for disconnecting the link assembly from the windshield wiper motor assembly. The installation process begins with attaching the windshield wiper motor assembly using three bolts at 5.4 N.m (55 Kgf.cm, 48 in.lbf) torque value while positioning the crank arm as necessary. After that, apply MP grease to the crank arm pivot before placing the No. 2 windshield wiper link rod on its pivot point. Connect the windshield wiper motor and link assembly using 4 bolts which need tightening to 7.5 N.m (77 Kgf.cm, 66 in.lbf). Follow proper bolt sequence and connect the wiring connector afterwards. Install the cowl top ventilator louver sub-assembly by joining its 4 claws and installing 2 clips while reinstalling the front fender to cowl side seal on the right hand side then the left hand side seal by engaging the claws for both. To install the front wiper arm and blade assembly LH you should clean the wiper arm serrations after operating the wiper until the windshield wiper motor stops at its automatic stop position. Then use a wire brush to clean the wiper pivot serrations followed by install the assembly with the nut which must be torqued to 20 N.m (204 Kgf.cm, 15 ft.lbf) while holding the arm hinge with one hand. Follow the same installation process for the right-hand front wiper arm assembly by assuring that wipers activate adequately during washer fluid spraying without coming into contact with the body structure.