Other Name: Belt Assembly, Rear Seat; Seat Belt Receptacle, Rear; Latch; Belt Assembly, Rear Seat, Inner Passenger Side; Belt Assembly, Rear Seat, Inner Driver Side
Manufacturer Note: GRAY,TRIM1#
Position: Rear
Replaces: 73580-60090-B0
Item Weight: 0.80 Pounds
Condition: New
Fitment Type: Direct Replacement
SKU: 73580-60090-B1
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
More Info
Fits the following 2006 Toyota Land Cruiser Submodels:
Other Name: Belt Assembly, Front Seat; Seat Belt Receptacle, Front Right; Latch; Belt Assembly, Front Seat Inner, Driver Side
Manufacturer Note: STONE,TRIM1#
Position: Driver Side
Replaces: 73230-60380-A0
Part Name Code: 73240
Item Weight: 1.00 Pounds
Condition: New
Fitment Type: Direct Replacement
SKU: 73230-60380-B0
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
More Info
Fits the following 2006 Toyota Land Cruiser Submodels:
Base | 8 Cyl 4.7 L GAS
| Page 1 of 2 |Next >
1-20 of 29 Results
2006 Toyota Land Cruiser Seat Belt
Looking for affordable OEM 2006 Toyota Land Cruiser Seat Belt? Explore our comprehensive catalogue of genuine 2006 Toyota Land Cruiser Seat Belt. All our parts are covered by the manufacturer's warranty. Plus, our straightforward return policy and speedy delivery service ensure an unparalleled shopping experience. We look forward to your visit!
2006 Toyota Land Cruiser Parts Questions & Experts Answers
Q: How to remove and install the front Seat Belt assembly on the LH side on 2006 Toyota Land Cruiser?
A: The removal procedure for the LH side front seat outer belt assembly requires disconnecting the negative battery cable for 90 seconds so Air Bags stay inactive before initiating the operation. Use a screwdriver taped with tape in front of the front door scuff plate LH while removing it with front door opening trim Weather Strip LH along with rear door scuff plate LH and hydro-Weather Strip LH. Also take out the center pillar garnish lower LH. Next, replace the seat belt anchor cover cap along with the front seat outer belt assembly LH by ensuring the retractor will not disassemble but also protect the pretensioner wire harness. First disconnect the pretensioner connector according to the specified order then remove the two bolts and retractor and the bolt and shoulder anchor. New components should be used for installation along with correct torque tightening of the front seat outer belt which requires replacement of all worn-out components. The front seat outer belt assembly LH requires installation of a retractor with two bolts (5 N.m for upper and 42 N.m for lower) before pretensioner connector installation according to specification. Following this step, attach the shoulder anchor with a bolt at 42 N.m while installing the seat belt anchor cover cap and respective trim components. The final step includes reattaching the cable to the negative battery terminal before performing initialization because specific systems need this procedure when reinstalling the battery.