Other Name: Sensor, Speed, Front Right-Hand; ABS Wheel Speed Sensor, Front Right; Sensor, Wheel Speed; ABS Sensor; Front Speed Sensor; Sensor, Speed, Front Passenger Side; ABS Wheel Speed Sensor
Position: Front Passenger Side
Part Name Code: 89542
Item Weight: 0.90 Pounds
Item Dimensions: 10.1 x 6.5 x 2.2 inches
Condition: New
Fitment Type: Direct Replacement
SKU: 89542-20140
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
More Info
Fits the following 2005 Toyota Celica Submodels:
GT, GTS | 4 Cyl 1.8 L GAS
2005 Toyota Celica Speed Sensor
Looking for affordable OEM 2005 Toyota Celica Speed Sensor? Explore our comprehensive catalogue of genuine 2005 Toyota Celica Speed Sensor. All our parts are covered by the manufacturer's warranty. Plus, our straightforward return policy and speedy delivery service ensure an unparalleled shopping experience. We look forward to your visit!
2005 Toyota Celica Speed Sensor Parts Q&A
Q: How to service and repair the rear wheel speed sensor on 2005 Toyota Celica?
A: Start servicing the rear wheel speed sensor by taking out the wheel then disconnecting the speed sensor connection. To access the speed sensor you need to start by taking away the two pins holding it to the rear axle hub using a pin punch and hammer with Special Service Tool 09520-00031. Subsequently fasten the rear axle hub onto a soft jaw vise and make sure to replace the hub if you drop it or experience sudden impact. Use Special Service Tool: 09520-00031 (09520-00040, 09521-00020), 09950-00020 along with 2 bolts (Diameter: 12 mm, Pitch: 1.5 mm) to take out the speed sensor unit. Perform these actions gently to prevent damage to both parts. To replace the speed sensor wire harness you need to remove the seat cushion and seatback with quarter trim then disconnect wire harness connector at the body before removing two clamping bolts. Install new sensor wire harness under specified torque settings of 19 Nm (195 kgf-cm, 14 ft.lbs.) on lower arm side and 8.0 Nm (82 kgf-cm, 71 inch lbs.) on body side. Clean the sensor surface areas of both the axle hub and new unit before placing the speed sensor onto the axle hub with connector downward. Use 09214-76011 special service tool and a press to mount the new sensor into position gradually to prevent damage. Reinstall the rear wheel using 103 Nm (1,050 kgf-cm, 76 ft. lbs.) torque before checking the speed sensor signal after connecting it to the speed sensor.