Other Name: Absorber Assembly, Shock; Front Shock Absorber; Suspension Kit; Strut Assembly; Shock Set; Strut Kit; Strut; Absorber Assembly, Shock, Front Passenger Side; Absorber Assembly, Shock, Front Driver Side; Shock
Replaces: 48510-39665
Item Weight: 9.50 Pounds
Item Dimensions: 26.6 x 8.2 x 7.7 inches
Condition: New
Fitment Type: Direct Replacement
SKU: 48510-09270
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
More Info
Fits the following 2001 Toyota Tacoma Submodels:
Base, DLX, Limited, Pre Runner, SR5, S-Runner | 4 Cyl 2.4 L GAS, 4 Cyl 2.7 L GAS, 6 Cyl 3.4 L GAS
2001 Toyota Tacoma Shock Absorber
Looking for affordable OEM 2001 Toyota Tacoma Shock Absorber? Explore our comprehensive catalogue of genuine 2001 Toyota Tacoma Shock Absorber. All our parts are covered by the manufacturer's warranty. Plus, our straightforward return policy and speedy delivery service ensure an unparalleled shopping experience. We look forward to your visit!
2001 Toyota Tacoma Shock Absorber Parts Q&A
Q: How to service the front shock absorber on 2001 Toyota Tacoma?
A: The service of front shock absorber must start with front wheel removal which demands a torque setting of 110 Nm (1,150 kgf-cm, 83 ft. lbs.). Proceed by disconnecting the shock absorber from the lower suspension arm where you must use a torque tool to remove its 2 bolts which need a setting of 39 Nm (400 kgf-cm, 29 ft. lbs.). Secure the shock absorber rod after which you should remove the nut and retainer along with cushion and shock absorber while tightening to 25 Nm (250 kgf-cm, 18 ft. lbs.). Check for irregularities when inspecting the shock absorber by pushing and pulling its rod. Replace it in case of any detected abnormalities. To eliminate unwanted gas, stretch the shock absorber rod to its full length before drilling a hole into the cylinder while preventing chip flying while drilling occurs. Operation proceeds the opposite direction as decomissioning.