Toyota 86160-0C070
Instrument Panel Speaker, Front

Deinstallation of the luggage speaker requires starting by removing the No. 2 deck board sub-assembly followed by removing the luggage compartment trim box lastly removing the rope hook assembly. The next tasks involve removing the No. 1 deck board sub-assembly together with the deck board reinforcement sub-assembly and deck board bracket. Proceed to take off the rear No. 2 seat assembly from the right-hand side according to manual seat or power seat configurations. Perform this operation once again for the left-hand side rear No. 2 seat assembly. You should remove the rear seat cushion hinge lower covers from both right and left sides after which you should remove the rear floor step covers (No. 1 and No. 2) before completing the removal of rear door scuff plates on both sides. First complete the removal of rear door opening trim Weather Strips from both sides before taking out the rope hook assembly for a second time alongside the rear floor mat support plate. Both right and left sides of quarter trim panel assemblies should be taken out for standard seat and power seat configurations. Remove both rear window No. 2 side garnish assemblies from both sides yet proceed only when the power back door is in the vehicle. To access the both side quarter speaker assemblies disconnect connectors and disengage guides before removing bolts and finally proceed to remove w/box No.1 speakers for fourteen speakers by disconnecting their connector followed by bolt removal.

Turn the ignition switch off and disconnect the negative battery cable for 90 seconds before starting to work. The same procedures apply to both the LH and RH sides, with the following steps focusing on the LH side: remove the front door lower frame bracket garnish LH, the front door inside handle bezel plug LH, the front armrest upper base panel LH (with power window), the front door window regulator handle assembly (without power window), the courtesy light assembly (with power window), the front door armrest cover LH, the front door trim board sub-assembly LH, and the front No.1 speaker assembly by disconnecting the speaker connector and removing the 4 screws. You should avoid placing hands on the speaker cone during this process. For installation, temporarily attach the speaker by securing the claws to the door panel, then install it with the 4 screws in the specified order, reconnect the connector, and proceed to install the front door trim board sub-assembly LH, the front door armrest cover LH, the courtesy light assembly (with power window), the front door window regulator handle assembly (without power window), the front armrest upper base panel LH (with power window), the front door inside handle bezel plug LH, and the front door lower frame bracket garnish LH. After these steps complete connect the cable to the negative battery terminal but remember that some systems need to be initialized following the connection.

Begin by installing the w/box No. 1 speaker assembly using 4 bolts, torqued to 7.0 Nm (71 kgf-cm, 62 in-lbf), and connect the connector.

Remove the front pillar garnish on the left and right sides.

Repeat the process for the front No. 2 speaker assembly LH.

Detach the 4 clips and claw with a screwdriver, and it is recommended to tape the screwdriver tip beforehand.

Install the rear seat assembly LH, ensuring to connect the rear seat No. 2 reclining control cable sub-assembly.

First, remove the rear door scuff plate LH.

Detach the 4 clips and claw with a screwdriver, and it is recommended to tape the screwdriver tip beforehand.