Install the axle hub by placing it onto the beam with 4 bolts that require a torque value of 90 Nm (918 kgf-cm, 67 ft-lbf). Check the rear axle hub bearing as a part of the equipment inspection. Vehicles with ABS require the installation of the skid control sensor wire connector. You should install the rear brake drum sub-assembly before adjusting the rear drum brake shoe clearance. Use a torque wrench to tighten the rear wheel to a value of 103 Nm (1,050 kgf-cm, 76 ft-lbf). Connect the cable to the negative battery terminal while torquing it to 5.4 Nm pressure equivalent to 55 kgf-cm or 48 in-lbf. Conclude the inspection by checking the ABS sensor signal in vehicles that come with ABS technology.