Question 1

How to install the rear Car Speakers assembly and complete the subsequent components on Toyota Yaris?

Accepted Answer

You must first fasten the speaker to the body by using its two claws followed by temporary installation then proceed with using an air riveter or hand riveter to place three new strike rivets onto the quarter panel. An air riveter or hand riveter should be used to attach the rear speaker assembly onto the quarter panel by inserting 3 new strike rivets in the correct order according to the provided illustration. Use the air or hand riveter to drive new strike rivets into position yet avoid damaging them by not prying the rivet heads. Verify the rivets reach all the way to the speaker area before inspecting to ensure the speaker remains flat against the speaker panels and that no gaps exist between any components while both pieces are secured together. Connect the speaker connector afterward. The sequence of installation includes the front quarter trim panel assembly with the front door opening trim Weather Strip and front door scuff plate. The rear seat assembly installation requires the RH side and LH side components matching the 60/40 Split Seat Type procedure followed by application of both the No. 2 and No. 1 rear seat leg covers for all sides. Continue installing the rear seatback assembly alongside the rear seat cushion cover pad sub-assembly designed for Hold Down Seat Type. The installation process for the deck floor box should mirror each other for both right-hand and left-hand sides of the vehicle. The installation requires placing the deck board sub-assembly together with the package tray trim panel assembly. Use a torque wrench to fasten the cable onto the negative battery terminal until it reaches 5.4 Nm (55 kgf-cm, 48 in-lbf).

Question 2

How to remove the rear package tray Car Speakers on Toyota Yaris?

Accepted Answer

The first step to remove the rear package tray speaker requires disconnecting the cable from the negative battery terminal. To perform work on the 60/40 Split Seat Type start by taking out the sub-assembly of the rear seat cushion cover pad then detach both rear seatback assemblies on right-hand and left-hand sides. The procedure for Removing the Rear Seatback Assembly applies only to the Fixed Seat Type. As the next step remove the luggage compartment floor mat alongside the spare wheel cover assembly and luggage compartment trim inner pad. The first step involves removing both rear door scuff plates before proceeding with the rear door opening trim Weather Strips removal. Remove the rear seat side covers together with roof side inner garnishes from both vehicle sides. When lighting components exist it is necessary to remove high mounted stop lights. Use a clip remover to disconnect the four clips and release the five claws from the package tray trim panel assembly to remove it and its trim pad before disconnecting the speaker connector for removal of the 4 bolts securing the rear speaker assembly.

OEM Toyota Yaris Car Speakers

9 Car Speakers found

Toyota Yaris Door Speaker, Rear

Toyota Yaris Front Driver Speaker, Rear

Toyota Yaris Rear Speaker

Toyota Yaris Door Speaker, Rear

Toyota Yaris Windshield Pillar Speaker, Front

Toyota Yaris Door Speaker, Rear

Toyota Yaris Windshield Pillar Speaker, Upper

Toyota Yaris Instrument Panel Speaker, Front

Toyota Yaris Rear Speaker

Toyota Yaris Car Speakers

Toyota Yaris Car Speakers Parts and Q&A

Related Toyota Yaris Parts

Browse Toyota Yaris Car Speakers by Years