Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
Fits the following Vehicles:
2001-2003 Toyota Sienna | CE, LE, XLE | 6 Cyl 3.0 L GAS
| Page 1 of 3 |Next >
1-20 of 46 Results
Toyota Sienna Exhaust Pipe
If you're thinking about purchasing OEM parts for your Toyota Sienna, our website is your one-stop destination. We stock an extensive selection of genuine Toyota Sienna Exhaust Pipe at pocket-friendly prices. Plus, we guarantee a swift delivery and a hassle-free return policy for your convenience.
Toyota Sienna Exhaust Pipe Parts Questions & Experts Answers
Q: How to install the exhaust pipe on Toyota Sienna?
A: You must start your 4WD vehicle installation of the 2GR-FE engine exhaust pipe by adding a heated Oxygen Sensor component for Bank 2 Sensor 2. The front exhaust pipe assembly demands 2 new gaskets to be installed while 2 nuts get torqued to 62 Nm (632 kgf-cm, 46 ft-lbf). The center exhaust pipe assembly needs two new gaskets installed before adding two exhaust pipe supports which need to be bolted and further secured by two new bolts and 2 nuts at 43 Nm (438 kgf-cm, 32 ft-lbf) and 62 Nm (632 kgf-cm, 46 ft-lbf) torque specifications respectively. Use 2 new nuts to secure the No. 1 exhaust pipe support bracket to the oil pan sub-assembly by torquing them to 21 Nm (214 kgf-cm, 15 ft-lbf). Complete this operation by letting loose the bracket bolts before installing the clamp onto the bracket then tightening the bolts to 21 Nm (214 kgf-cm, 15 ft-lbf). The Bank 2 Sensor 2 heated oxygen sensor needs a clamp with a new bolt secured at 21 Nm (214 kgf-cm, 15 ft-lbf) before sensor connection. The tail exhaust pipe assembly needs a new gasket on the center exhaust pipe assembly before attaching four supports with 2 new bolts that should be torqued to 43 Nm (438 kgf-cm, 32 ft-lbf). The last step is the heated oxygen sensor for Bank 1 Sensor 2 installation together with negative terminal cable connection and exhaust gas leak inspection with required part replacement or repairs.