The front shoulder belt anchor adjuster assembly requires two bolts to secure while matching its positioning claw to the hole and tightening them to 42 Nm (428 kgf-cm, 31 ft-lbf). The process of front seat outer belt installation requires 2 bolts attachment. Begin by screwing bolt A to a torque of 8.0 Nm (82 kgf-cm, 71 in-lbf) followed by securing bolt B at 42 Nm (428 kgf-cm, 31 ft-lbf). Connect the pretensioner connector and fasten the shoulder anchor to the shoulder belt anchor adjuster using a nut which must have a torque of 42 Nm (428 kgf-cm, 31 ft-lbf). The installation process includes attaching the center pillar garnish RH followed by lower center pillar garnish RH, rear door opening trim Weather Strip RH and rear door scuff plate RH, rear floor step No. 1 cover and finishing with front door opening trim Weather Strip RH along with front door scuff plate RH. Mount the front seat assembly LH according to the manual and power seat guidelines. To complete the procedure use a torque wrench to fasten the cable to the negative battery terminal at 5.4 Nm (55 kgf-cm, 48 in-lbf) yet initialization procedures might be necessary following the reconnection steps.