Other Name: Computer, Engine Control; Engine Control Module
Replaces: 89661-0CJ50, 89661-0CJ51
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
Fits the following Vehicles:
2010 Toyota Sequoia | Limited, SR5 | 8 Cyl 4.6 L GAS
| Page 1 of 4 |Next >
1-20 of 65 Results
Toyota Sequoia Engine Control Module
If you're thinking about purchasing OEM parts for your Toyota Sequoia, our website is your one-stop destination. We stock an extensive selection of genuine Toyota Sequoia Engine Control Module at pocket-friendly prices. Plus, we guarantee a swift delivery and a hassle-free return policy for your convenience.
Toyota Sequoia Engine Control Module Parts and Q&A
Q: How to install the Engine Control Module (ECM) on Toyota Sequoia?
A: In order to fit the ECM to 2UZ-FE engine, clean the area of the seal, put on another gasket, and screw the ECM in place using 4 bolts. Connect ECM connectors, and make sure that the lock lever is raised. Install air cleaner assembly, attach the mass air flow meter and reconnect the negative battery post, with any necessary initiation being required.
Q: How to remove and replace the Engine Control Module (ECM) on Toyota Sequoia?
A: In order to change the Engine Control Module (ECM) of the 2UZ-FE engine, one needs to disconnect the negative battery terminal and take off the throttle body cover and air cleaner assembly, and the connector holder block. Then, unscrew the wire harness, lift the levers, and take the connectors and bolts out, and take the gasket tape out carefully.