Other Name: Absorber Set, Shock; Absorber Assembly, Shock, Rear Passenger Side; Absorber Assembly, Shock, Rear Driver Side
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
Fits the following Vehicles:
2016-2018 Toyota Prius | Four, Four Touring, One, Three, Three Touring, Two, Two Eco | 4 Cyl 1.8 L FULL HYBRID EV-GAS (FHEV)
| Page 1 of 2 |Next >
1-20 of 29 Results
Toyota Prius Shock Absorber
If you're thinking about purchasing OEM parts for your Toyota Prius, our website is your one-stop destination. We stock an extensive selection of genuine Toyota Prius Shock Absorber at pocket-friendly prices. Plus, we guarantee a swift delivery and a hassle-free return policy for your convenience.
Toyota Prius Shock Absorber Parts Questions & Experts Answers
Q: How to service and repair the Shock Absorber on Toyota Prius?
A: You must begin suspension strut repair and service by compressing the coil spring using Special Service Tool: 09727-30021 (09727-00010, 09727-00021, 09727-00031) but do not use an impact wrench due to risk of damaging the tool. First use a 6 mm hexagon wrench to grasp the piston rod before removing the nut followed by removing the support plate and cushion as well as the spring bracket and upper insulator and suspension support and spring bumper and coil spring in sequence. The shock absorber should be inspected while pressing and extending the rod to listen for unusual sounds and abnormal resistance; any discovered problems require shock absorber replacement. Apply the following procedure for shock absorber disposal by extending the rod fully before drilling a hole into the cylinder while watching for chips and being aware of the non-toxic and odorless and colorless nature of the gas. Pressuring the coil spring using Special Service Tool: 09727-30021 (09727-00010, 09727-00021, 09727-00031) enables its insertion into the shock absorber with the lower segment fitting to the spring lower seat gap. Begin by placing the spring bumper followed by suspension support and upper insulator and spring bracket, cushion and suspension plate. Tighten the center nut only momentarily. Contrary to initial installation, use Special Service Tool: 09727-30021 (09727-00010, 09727-00021, 09727-00031) to check spring bracket direction prior to securing the nut to 56 Nm (571 kgf-cm, 41 ft. lbs.) with a 6 mm hexagon wrench holding the piston rod in place.