Other Name: Motor Sub-Assembly, Blower; HVAC Blower Motor Assembly, Rear; Blower Assembly; Fan & Motor; Motor Sub-Assembly, Blower W/Fan(For Rear); HVAC Blower Motor
Position: Rear
Replaces: 87103-28110
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
Fits the following Vehicles:
2013-2021, 2008-2011 Toyota Land Cruiser | Base, Heritage Edition | 8 Cyl 5.7 L GAS
Other Name: Motor Sub-Assembly, Blower; HVAC Blower Motor Assembly; HVAC Blower Motor, Rear; Blower Assembly; Motor Sub-Assembly, Blower W/Fan(For Rear)
Position: Rear
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
Fits the following Vehicles:
1998-2002 Toyota Land Cruiser | Base | 8 Cyl 4.7 L GAS
Other Name: Motor Sub-Assembly, Blower; Motor Sub-Assembly, Rear Heater Blower; Motor Sub-Assembly, Heater Blower
Manufacturer Note: REAR
Position: Rear
Warranty: This genuine part is guaranteed by Toyota's
factory warranty.
Fits the following Vehicles:
1988-1990 Toyota Land Cruiser | Base | 6 Cyl 4.0 L GAS
| Page 1 of 2 |Next >
1-20 of 24 Results
Toyota Land Cruiser Blower Motor
If you're thinking about purchasing OEM parts for your Toyota Land Cruiser, our website is your one-stop destination. We stock an extensive selection of genuine Toyota Land Cruiser Blower Motor at pocket-friendly prices. Plus, we guarantee a swift delivery and a hassle-free return policy for your convenience.
Q: How to service the blower motor on Toyota Land Cruiser?
A: To service the blower motor, disconnect the negative battery terminal and wait 90 seconds to avoid Air Bag activation. After installation, perform initialization if required. Remove the blower motor by disconnecting the connector and unscrewing three screws, then reverse the steps for installation.
Q: How to service and repair the blower motor on Toyota Land Cruiser?
A: To service the blower motor, start by removing the HVAC housing assembly from the air conditioning unit. Then, take out the blower assembly by unscrewing it, disconnecting the connector and clamp, detaching the claw, and finally removing the blower unit.