The generator assembly needs installation through two bolt attachments with Bolt A requiring 25 Nm (250 kgf-cm, 18 ft-lbf) torque and Bolt B needing 54 Nm (550 kgf-cm, 40 ft-lbf) torque. Begin by joining connector [B] then clamp the wire harness with component [C] followed by generator connector [D] attachment. When attaching the generator wire with the nut [E] continue until the torque reaches 9.8 Nm (100 kgf-cm, 87 in-lbf). Installation of terminal cap No. 2 follows the previous step. Install the fan and generator V belt before covering the engine with the right-hand under cover. Finish the wiring process by torquing the negative battery terminal up to 5.4 Nm (55 kgf-cm, 48 in-lbf).