How to Service and Repair the Timing Cover on Toyota Avalon?

The service process for the 2GR-FE timing chain or belt cover sub-assembly starts with removing the engine assembly with transaxle and several additional components including engine wire, front frame assembly, starter assembly, automatic transaxle assembly, oil level gauge guide sub-assembly, exhaust manifold sub-assemblies (RH and LH), drive plate & ring gear sub-assembly, and idler pulley sub-assembly No.2. The first step requires removal of the V-ribbed belt tensioner assembly with water pump pulley, water inlet housing, crankshaft pulley, oil pan sub-assemblies (No.2 and main), oil strainer sub-assembly, intake air surge tank, ignition coil assembly, and oil pipes No.1 and No.2. To detach the cylinder head cover sub-assemblies (RH and LH) along with the timing chain or belt cover sub-assembly you must remove 23 bolts and 2 nuts before carefully prying them off and afterward removing the gasket. After prying out the timing gear case or timing chain case oil seal with a screwdriver you should replace it with a new oil seal using Special Service Tool: 09316-60011 (09316-00011) while ensuring the seal rests directly on the timing chain case edge and coating the oil seal lip with MP grease. Seal packing (Part No. 08826-00080 or equivalent) needs to be applied as a continuous bead between the engine unit and timing chain cover after ensuring both surfaces are clean and dry before installing the sub-assembly within 3 minutes and tightening the bolts within 15 minutes. Install a new gasket then position the drive rotor spline of the oil pump correctly to the crankshaft before loosely installing the timing chain cover followed by careful bolt tightening in specified sequence to proper torque specifications. Finally, reinstall the cylinder head cover sub-assemblies (LH and RH), oil pipes, ignition coil assembly, intake air surge tank, oil pan sub-assemblies, crankshaft pulley, water inlet housing, water pump pulley, V-ribbed belt tensioner assembly, idler pulley sub-assembly No.2, drive plate & ring gear sub-assembly, exhaust manifold sub-assemblies, oil level gauge guide sub-assembly, automatic transaxle assembly, starter assembly, front frame assembly, engine wire, and the engine assembly with transaxle.

OEM Toyota Avalon Timing Cover

Engine Timing Cover

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

12 Timing Covers found

View related parts
Toyota Avalon Cover, Timing Belt, Upper Inner
Part Number: 11323-20030
$171.54 MSRP: $242.83
You Save: $71.29 (30%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Timing Cover
- Position: Upper Inner
- Warranty: This genuine part is guaranteed by Toyota's factory warranty.
Fits the following Vehicles:
- 1998-2004 Toyota Avalon | XL, XLS | 6 Cyl 3.0 L GAS
View related parts
Toyota Avalon Timing Cover, Upper Outer
Part Number: 11303-20040
$91.00 MSRP: $127.73
You Save: $36.73 (29%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Cover Sub-Assembly, Timing Chain; Engine Timing Cover, Outer Upper; Front Cover; Upper Timing Cover; Outer Timing Cover; Cover, Timing Belt
- Manufacturer Note: (J)
- Position: Upper Outer
- Replaces: 11303-0A031, 11303-0A030
- Warranty: This genuine part is guaranteed by Toyota's factory warranty.
Fits the following Vehicles:
- 1999-2004 Toyota Avalon | XL, XLS | 6 Cyl 3.0 L GAS
View related parts
Toyota Avalon Timing Cover
Part Number: 11310-0V020
$308.95 MSRP: $441.11
You Save: $132.16 (30%)
ADD TO CART
Product Specifications
- Other Name: Cover Assembly, Timing Chain Or Belt; Engine Timing Cover; Front Cover; Cover Sub-Assembly, Timing Chain Or Belt; Cover Assembly, Timing Chain
- Replaces: 11310-36040, 11310-0V030, 11310-36020
- Warranty: This genuine part is guaranteed by Toyota's factory warranty.
Fits the following Vehicles:
- 2013-2018 Toyota Avalon | Hybrid Limited, Hybrid XLE, Hybrid XLE Plus, Hybrid XLE Premium, Hybrid XLE Touring | 4 Cyl 2.5 L FULL HYBRID EV-GAS (FHEV)
View related parts
Toyota Avalon Timing Cover
Part Number: 11310-0P050
$691.88 MSRP: $1013.96
You Save: $322.08 (32%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Cover Assembly, Timing Chain Or Belt; Engine Timing Cover; Engine Oil Pump; Front Cover; Cover Assembly, Timing Chain
- Warranty: This genuine part is guaranteed by Toyota's factory warranty.
Fits the following Vehicles:
- 2019-2022 Toyota Avalon | Limited, Touring, TRD, XLE, XSE, XSE Nightshade | 6 Cyl 3.5 L GAS
View related parts
Toyota Avalon Timing Cover, Lower
Part Number: 11302-0A020
$55.56 MSRP: $77.32
You Save: $21.76 (29%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Cover Sub-Assembly, Timing Chain; Engine Timing Cover, Lower; Front Cover; Outer Timing Cover; Cover, Timing Belt
- Manufacturer Note: (L)
- Position: Lower
- Replaces: 11302-20040
- Warranty: This genuine part is guaranteed by Toyota's factory warranty.
Fits the following Vehicles:
- 1999-2004 Toyota Avalon | XL, XLS | 6 Cyl 3.0 L GAS
View related parts
Toyota Avalon Front Cover, Upper Outer
Part Number: 11322-0A010
$92.24 MSRP: $129.47
You Save: $37.23 (29%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Cover, Timing Belt; Engine Timing Cover, Outer Upper; Timing Cover
- Manufacturer Note: (L)
- Position: Upper Outer
- Replaces: 11322-20900, 11322-20901, 11322-20010, 11322-20011
- Warranty: This genuine part is guaranteed by Toyota's factory warranty.
Fits the following Vehicles:
- 1995-1999 Toyota Avalon | XL, XLS | 6 Cyl 3.0 L GAS
View related parts
Toyota Avalon Timing Cover, Outer
Part Number: 11320-F0010
$222.74 MSRP: $318.02
You Save: $95.28 (30%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Cover Assembly, Timing Chain Or Belt; Engine Timing Cover, Outer; Front Cover; Outer Timing Cover; Cover Assembly, Timing Chain
- Position: Outer
- Warranty: This genuine part is guaranteed by Toyota's factory warranty.
Fits the following Vehicles:
- 2019-2022 Toyota Avalon | Hybrid Limited, Hybrid XLE, Hybrid XSE, Hybrid XSE Nightshade, Limited, XLE | 4 Cyl 2.5 L FULL HYBRID EV-GAS (FHEV), 4 Cyl 2.5 L GAS
View related parts
Toyota Avalon Cover Assembly, Timing Chain, Inner
Part Number: 11310-F0010
$222.50 MSRP: $317.68
You Save: $95.18 (30%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Case Assembly, Timing Chain Or Belt; Timing Cover
- Position: Inner
- Replaces: 11310-25030
- Warranty: This genuine part is guaranteed by Toyota's factory warranty.
Fits the following Vehicles:
- 2019-2022 Toyota Avalon | Hybrid Limited, Hybrid XLE, Hybrid XSE, Hybrid XSE Nightshade, Limited, XLE | 4 Cyl 2.5 L FULL HYBRID EV-GAS (FHEV), 4 Cyl 2.5 L GAS
View related parts
Toyota Avalon Timing Cover, Lower
Part Number: 11310-31020
$623.78 MSRP: $914.16
You Save: $290.38 (32%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Cover Assembly, Timing Chain Or Belt; Engine Timing Cover, Lower; Front Cover; Lower Timing Cover; Cover Sub-Assembly, Timing Chain Or Belt
- Manufacturer Note: (J)
- Position: Lower
- Replaces: 11310-0P041, 11310-0P040
- Warranty: This genuine part is guaranteed by Toyota's factory warranty.
Fits the following Vehicles:
- 2005-2018 Toyota Avalon | Base, Limited, Touring, XL, XLE, XLE Plus, XLE Premium, XLE Touring, XLE Touring SE, XLS | 6 Cyl 3.5 L GAS
View related parts
Toyota Avalon Cover, Timing Belt, Upper Outer
Part Number: 11322-20030
Product Specifications
- Other Name: Timing Cover
- Manufacturer Note: (J)
- Position: Upper Outer
- Warranty: This genuine part is guaranteed by Toyota's factory warranty.
Fits the following Vehicles:
- 1998-1999 Toyota Avalon | XL, XLS | 6 Cyl 3.0 L GAS
View related parts
Toyota Avalon Cover, Timing Belt, Lower
Part Number: 11321-0A010
Product Specifications
- Other Name: Timing Cover
- Manufacturer Note: (L)
- Position: Lower
- Replaces: 11321-20010, 11321-20020, 11321-20900
- Warranty: This genuine part is guaranteed by Toyota's factory warranty.
Fits the following Vehicles:
- 1995-1999 Toyota Avalon | XL, XLS | 6 Cyl 3.0 L GAS
View related parts
Toyota Avalon Timing Cover
Part Number: 11304-20902
Product Specifications
- Other Name: Cover Sub-Assembly Belt; Front Cover; Upper Timing Cover; Inner Timing Cover; Cover, Timing Belt
- Replaces: 11304-20020, 11304-20900, 11304-20010
- Warranty: This genuine part is guaranteed by Toyota's factory warranty.
Fits the following Vehicles:
- 1995-1997 Toyota Avalon | XL, XLS | 6 Cyl 3.0 L GAS

Toyota Avalon Timing Cover

Choose genuine Timing Cover that pass strict quality control tests. You can trust the top quality and lasting durability. Shopping for OEM Timing Cover for your Toyota Avalon? Our website is your one-stop destination. We stock an extensive selection of genuine Toyota Avalon parts. The price is affordable so you can save more. It only takes minutes to browse and find the exact fit. Easily add to cart and check out fast. Our hassle-free return policy will keep you stress-free. We process orders quickly for swift delivery. Your parts will arrive faster, so you can get back on the road sooner.

The Toyota avalon timing cover is a component that has copper much importance when it comes to the performance of the vehicle's timing mechanism that includes a timing belt, timing chain or cam belt. The Timing Cover is considered one of the most reliable and high-performance parts of the car; it is made of such materials as aluminum, plastic, or steel to guarantee its work as a reliable protector of other delicate parts of the engine from dirt or damages. This protective feature ensures the efficiency or the full-sized sedan Toyota Avalon that is has been in the market since 1994. The Timing Cover is created to fit numerous Avalon models and guarantee that each model will have an opportunity to derive advantages from the incorporation of the mentioned part. Most of the Toyota Avalon Timing Covers are designed with gasket to boost their protective nature in the market today. Though they are very durable, one should pay attention to the Timing Cover to ensure it has not worn out as the replacement of the same is very crucial to ensure safety of the vehicle. globally the Toyota Avalon has had a good reputation in quality and safety and has been awarded many accolades such as the IIHS Top Safety Pick; hence it is important to ensure that parts such as the Timing Cover are reliable. In conclusion, a Toyota Avalon Timing Cover is not just an additional gadget that gives the vehicle's performance a boost, but it can be considered the main reason for the Avalon's endurance and protection out on the road.

Toyota Avalon Timing Cover Parts and Q&A

Timing Cover, Lower
11310-31020
Q: How to Service and Repair the Timing Cover on Toyota Avalon?
A:
The service process for the 2GR-FE timing chain or belt cover sub-assembly starts with removing the engine assembly with transaxle and several additional components including engine wire, front frame assembly, starter assembly, automatic transaxle assembly, oil level gauge guide sub-assembly, exhaust manifold sub-assemblies (RH and LH), drive plate & ring gear sub-assembly, and idler pulley sub-assembly No.2. The first step requires removal of the V-ribbed belt tensioner assembly with water pump pulley, water inlet housing, crankshaft pulley, oil pan sub-assemblies (No.2 and main), oil strainer sub-assembly, intake air surge tank, Ignition Coil assembly, and oil pipes No.1 and No.2. To detach the cylinder head cover sub-assemblies (RH and LH) along with the timing chain or belt cover sub-assembly you must remove 23 bolts and 2 nuts before carefully prying them off and afterward removing the gasket. After prying out the timing gear case or timing chain case oil seal with a screwdriver you should replace it with a new oil seal using Special Service Tool: 09316-60011 (09316-00011) while ensuring the seal rests directly on the timing chain case edge and coating the oil seal lip with MP grease. Seal packing (Part No. 08826-00080 or equivalent) needs to be applied as a continuous bead between the engine unit and timing chain cover after ensuring both surfaces are clean and dry before installing the sub-assembly within 3 minutes and tightening the bolts within 15 minutes. Install a new gasket then position the drive rotor spline of the oil pump correctly to the crankshaft before loosely installing the timing chain cover followed by careful bolt tightening in specified sequence to proper torque specifications. Finally, reinstall the cylinder head cover sub-assemblies (LH and RH), oil pipes, ignition coil assembly, intake air surge tank, oil pan sub-assemblies, crankshaft pulley, water inlet housing, water pump pulley, V-ribbed belt tensioner assembly, idler pulley sub-assembly No.2, drive plate & ring gear sub-assembly, exhaust manifold sub-assemblies, oil level gauge guide sub-assembly, automatic transaxle assembly, starter assembly, front frame assembly, engine wire, and the engine assembly with transaxle.