OEM Scion xA Sway Bar Kit

Scion xA Sway Bar Kit Parts Questions & Experts Answers

• Stabilizer Bar, Front
  48811-52021
  Q: How to replace the front Sway Bar Kit on Scion xA?

  A: The replacement of the front sway bar kit requires disassembling the front wheels along with the hood sub-assembly followed by suspension of the engine assembly. The procedure starts with separating the front suspension arm sub-assembly lower No.1 LH through Special Service Tool: 09628-00011 followed by identical procedures for separating the front suspension arm sub-assembly lower No.1 RH. The front sway bar kit removal begins with disconnecting the front sway bar kit and power steering link assembly and pressure feed tube assembly and front suspension crossmember sub-assembly before removing the sway bar kit through the front sway bar bracket No.1 LH and RH bolt and bushing extraction. Install the sway bar kit together with both brackets and bushings by using 4 bolts and torque them to 37 Nm (375 kgf-cm, 27 ft. lbs.). The bushings must have their slit facing the rear of the vehicle and position outside each paint line. First connect the front suspension crossmember sub-assembly with the pressure feed tube assembly and power steering link assembly and the front sway bar kit before installing the front suspension arm sub-assembly lower No.1 LH and No.1 RH pieces. These steps apply the same procedure for both sides. The last stage involves tightening front wheels to 103 Nm (1,050 kgf-cm, 76 ft. lbs.), reattaching the hood sub-assembly, conducting hood sub-assembly inspections and adjustments and performing an alignment check on the front wheels.