OEM Scion tC Clutch Master Cylinder

Scion tC Clutch Master Cylinder Parts and Q&A

• Cylinder Kit, Clutch Master
  04311-12110
  Q: How to remove and replace the Clutch Master Cylinder on Scion tC?

  A:

  The first step to replace the Clutch Master Cylinder is draining brake fluid before immediately washing off all affected painted surfaces. The first step involves removing both Brake Master Cylinder sub-assembly coupled with the Brake Booster assembly from the vehicle. Remove the clutch reservoir tube by unscrewing the clip while detaining the fluid through a container. Prior to disconnecting the clutch master cylinder flexible hose tube use Special Service Tool: 09023-00101 while placing fluids into a container. The procedure ends with removing the clip and hole pin from the clutch master cylinder push rod clevis hole before extracting the clutch master cylinder assembly by loosening its two retaining nuts.
• Master Cylinder
  31420-20070
  Q: How to install the clutch master cylinder assembly on Scion tC?

  A:

  Two nuts must be used to secure the clutch master cylinder assembly by following a torque setting of 12 Nm (120 kgf-cm, 9 ft-lbf). First apply MP grease to the hole pin contact surface and clevis bush contact points then join the clutch pedal to the clevis through the hole pin from the right vehicle side and secure with a clip. The installation of the clutch master cylinder assembly requires Special Service Tool: 09023-00101 to attach it to the flexible hose tube while torquing at 15 Nm (155 kgf-cm, 11 ft-lbf). Install the clutch reservoir tube on the clutch master cylinder using a clip which should have its red marking facing toward the top. The Brake Booster assembly should be mounted together with the Brake Master Cylinder sub-assembly. After brake fluid fills the reservoir you must bleed both the brake line and clutch pipe line using appropriate torque of 8.4 Nm (85 kgf-cm, 74 in-lbf). Verify the brake pedal height followed by clutch pedal sub-assembly adjustment and examine both systems for noticeable fluid leaks. End your procedure by inspecting the fluid level that exists in the reservoir.